[cisco-voip] Single button ARD

[Austin Williams]

What are your gateways built with, MGCP, H323, SIP? What version of call
manager are you working on?

Ringdowns for call managers are built using CSSs, Partitions and a Null
Translation pattern.

Here is a good article on it:
https://www.networkcomputing.com/networking/using-cucm-configure-plar-phones

On Fri, Oct 8, 2021 at 11:19 AM Matthew Huff <mhuff at ox.com> wrote:

> I’m trying to setup a button on people’s phone where they will get inbound
> calls like a (DN) when voice-port goes off-hook on our gateway (connection
> plar xxxx). When the button is pressed on any phone, it should do the
> same thing, take the channel off hook on the voice gateway.
>
>
>
> All the example’s I’ve seen are for doing PLAR when the phone goes offhook
> or the “new call button” is pressed, but not a separate line.
>
>
>
> I’ve done this in the past with CME like:
>
>
>
>
>
> voice-port 0/3/1:0
>
> define Tx-bits idle 1111
>
> define Tx-bits seize 0000
>
> define Rx-bits idle 1111
>
> define Rx-bits seize 0000
>
> no vad
>
> no comfort-noise
>
> connection plar B100
>
>
>
> ephone-dn  32
>
> number B100
>
> trunk B101
>
>
>
> *Matthew Huff* | Director of Technical Operations | OTA Management LLC
>
>
>
> *Office: 914-460-4039*
>
> *mhuff at ox.com <mhuff at ox.com> | **www.ox.com <http://www.ox.com>*
>
>
> *...........................................................................................................................................*
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20211008/e8614883/attachment.htm>