[e-nsp] Summit 400-48t - sharing

[Marcin Kuczera]

hello,

I'am just testing sharing in Summit400-48t and... there is only dynamic 
algorythm that sais:
* Summit400-48t:16 # enable sharing 47 grouping 47,48 a
Next possible completions:
        <cr>

* Summit400-48t:16 # enable sharing 47 grouping 47,48 algorithm 
address-based

* Summit400-48t:17 # show ports 47 info detail
Port 47:
        Type:           UTP
        Diagnostic:     passed
        Admin state:    Enabled, with auto-duplex auto-speed sensing
        Link state:     Active.    Full-duplex 1000 Mbps.
        Link counter:   Up 6 time(s), Down 5 times(s)
        Link Filter counter:    Up 6 time(s), Down 5 times(s)
        VLAN cfg:
        test [802.1Q Tag=0100,Mac-Limit:Cfg=No-limit,LRN=37,BlkHole=0]

        STP cfg:
                s0(enable), Tag=(none), Mode=802.1D, State=FORWARDING

        Trunking:       Master port with 2 members using address-based 
algorithm
        Members:        47 48   [Current runtime master is 47]

well, if I set "dynamic" it is still address-based.

Will that allways be address based or can automatically switch to 
round-robin if the link is quite loaded ?
Or this switch can do only address based ?

In Alpine I could pick up round-robin method :(

Regards,
Marcin