[e-nsp] Summit 400-48t - sharing

[Manu Chao]

address-based only with this release/configuration


On Tue, Jul 14, 2009 at 2:49 PM, Marcin Kuczera <marcin at leon.pl> wrote:

> hello,
>
> I'am just testing sharing in Summit400-48t and... there is only dynamic
> algorythm that sais:
> * Summit400-48t:16 # enable sharing 47 grouping 47,48 a
> Next possible completions:
>       <cr>
>
> * Summit400-48t:16 # enable sharing 47 grouping 47,48 algorithm
> address-based
>
> * Summit400-48t:17 # show ports 47 info detail
> Port 47:
>       Type:           UTP
>       Diagnostic:     passed
>       Admin state:    Enabled, with auto-duplex auto-speed sensing
>       Link state:     Active.    Full-duplex 1000 Mbps.
>       Link counter:   Up 6 time(s), Down 5 times(s)
>       Link Filter counter:    Up 6 time(s), Down 5 times(s)
>       VLAN cfg:
>       test [802.1Q Tag=0100,Mac-Limit:Cfg=No-limit,LRN=37,BlkHole=0]
>
>       STP cfg:
>               s0(enable), Tag=(none), Mode=802.1D, State=FORWARDING
>
>       Trunking:       Master port with 2 members using address-based
> algorithm
>       Members:        47 48   [Current runtime master is 47]
>
> well, if I set "dynamic" it is still address-based.
>
> Will that allways be address based or can automatically switch to
> round-robin if the link is quite loaded ?
> Or this switch can do only address based ?
>
> In Alpine I could pick up round-robin method :(
>
> Regards,
> Marcin
> _______________________________________________
> extreme-nsp mailing list
> extreme-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/extreme-nsp
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/extreme-nsp/attachments/20090715/47386517/attachment.html>