[f-nsp] VRRP problem

[Brent Van Dussen]

Wow, Too early, disregard dead-interval adjustment, check vlan config 
instead and try using 'dm raw' command to watch for VRRP packets entering 
the switch management CPU.

-Brent


At 06:30 AM 6/1/2006, Brent Van Dussen wrote:
>Also, seems odd that Switch-2 has a dead-interval of 0, perhaps a nuance of
>the particular code running on there.  Try upping that dead interval to
>something like 5 seconds.
>
>-Brent
>
>At 11:58 AM 5/30/2006, barney gumbo wrote:
>
> >switch-2#sho ip vrrp
> >Total number of VRRP routers defined: 1
> >Interface ethernet v3
> >  auth-type no authentication
> >  VRID 3
> >   state master
> >   administrative-status enabled
> >   mode non-owner(backup)
> >   priority 100
> >   current priority 100
> >   hello-interval 1 sec
> >   dead-interval 0 sec
> >   current dead-interval 3.600 sec
> >   preempt-mode true
> >   ip-address <http://192.168.101.2/>192.168.101.2
> >   advertise backup: disabled
> >   next hello sent in 00:00:00
> >switch-2#
>
>_______________________________________________
>foundry-nsp mailing list
>foundry-nsp at puck.nether.net
>http://puck.nether.net/mailman/listinfo/foundry-nsp