[f-nsp] Multi-module trunk group

[Asoka De Saram]

Yes, it can be done.
Here is the proper syntax to configure a two port cross module trunk.

telnet at BigIron RX-8 Router(config-if-e1000-2/7)#trunk e 2/7 to 2/7 ethernet 6/1 to 6/1
Trunk transaction done.




----- Original Message ----
From: Andrea <bo.andrew at gmail.com>
To: foundry-nsp at puck.nether.net
Sent: Friday, August 17, 2007 9:06:32 AM
Subject: [f-nsp] Multi-module trunk group


Hi, I'm trying to configure some trunks on my bigiron-rx-8
with IronWare Version 2.2.1gT143

For redundacy reason I'd like to put in trunk group two ports in
different module, but the command is always rejected, example

slot 2 - 24 sfp module with 1000sx sfp (RX-BI-24F)
slot 6 - 24 sfp module with 1000sx sfp (RX-BI-24F)

command:
telnet at bigiron(config)#trunk eth 2/7 to 6/1
error - one port range must be within one module

I read documentation and I've checked that both ports have
the same vlan configuration, no ip address, acl and so on,
from foundry website seems tha it cuuld be done
http://www.foundrynet.com/services/documentation/bigiron_rx_config/Trunking.html#wp78363
but no example are present

Am I misunderstanding something?

Thanks in advance
Andrew
_______________________________________________
foundry-nsp mailing list
foundry-nsp at puck.nether.net
http://puck.nether.net/mailman/listinfo/foundry-nsp


       
____________________________________________________________________________________
Be a better Heartthrob. Get better relationship answers from someone who knows. Yahoo! Answers - Check it out. 
http://answers.yahoo.com/dir/?link=list&sid=396545433