[f-nsp] BigIron 4000 w/M4R4G Problem

[Raul Ayala]

I'm setting up a BI4000 with M4R4G and B8GC.  Instead of booting up
normally, it runs this message continuously until we shut it down.

BigIron Router#
BOOT INFO: RESET ANY
master arbitrate : primary arbitrator is already there.
BOOT INFO: Become standby CPU module
Enter standby loop...
No active module
master arbitrate : primary arbitrator is already there.

BigIron Router#
BOOT INFO: RESET ANY
master arbitrate : primary arbitrator is already there.
BOOT INFO: Become standby CPU module
Enter standby loop...
No active module
master arbitrate : primary arbitrator is already there.

BOOT INFO: RESET ACTIVE
master arbitrate : primary arbitrator is already there.
BOOT INFO: Become standby CPU module
Enter standby loop...
No active module
master arbitrate : primary arbitrator is already there.

And on, and on........


Is this a SW/config or HW issue? We've never seen this before.

Thanks in advance for any suggestions.

Raul

 

No virus found in this outgoing message.
Checked by AVG Free Edition. 
Version: 7.5.487 / Virus Database: 269.13.19/1008 - Release Date: 9/14/2007
8:59 AM