[f-nsp] FESX424-PREM - Catalyst 3750 GigE fibre connx problems

[Mark Tech]

Hi
I am trying to connact a FESX424 to a Catalyst 3750 via GigE fibre however I am not having any luck bringing the ports up. I can loop back to each local port and they come up, the fibre has been checked between the boxes but still no joy

Here is the output from the FESX:

#sh int e3
GigabitEthernet3 is down, line protocol is down
  Hardware is GigabitEthernet, address is 0012.f286.5d80 (bia 0012.f286.5d82)
  Configured speed auto, actual unknown, configured duplex fdx, actual unknown
  Configured mdi mode AUTO, actual unknown
  Member of L2 VLAN ID 504, port is untagged, port state is BLOCKING
  BPDU guard is Disabled, ROOT protect is Disabled
  Link Error Dampening is Disabled
  STP configured to ON, priority is level0
  Flow Control is config enabled, oper disabled, negotiation disabled
  mirror disabled, monitor disabled
  Not member of any active trunks
  Not member of any configured trunks
  IPG MII 96 bits-time, IPG GMII 96 bits-time
  IP MTU 1500 bytes, encapsulation ethernet
  300 second input rate: 0 bits/sec, 0 packets/sec, 0.00% utilization
  300 second output rate: 0 bits/sec, 0 packets/sec, 0.00% utilization
  1831 packets input, 120529 bytes, 0 no buffer
  Received 1 broadcasts, 1827 multicasts, 3 unicasts
  0 input errors, 0 CRC, 0 frame, 0 ignored
  0 runts, 0 giants
  1831 packets output, 120529 bytes, 0 underruns
  Transmitted 1 broadcasts, 1827 multicasts, 3 unicasts
  0 output errors, 0 collisions

And the Cisco:

sh int GigabitEthernet1/0/4
Load for five secs: 5%/0%; one minute: 9%; five minutes: 6%
Time source is NTP, 10:41:19.790 GMT Thu Oct 16 2008
GigabitEthernet1/0/4 is down, line protocol is down (notconnect)
  Hardware is Gigabit Ethernet, address is 0021.d7d6.6084 (bia 0021.d7d6.6084)
  Description: To T9K
  MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive not set
  Auto-duplex, Auto-speed, link type is auto, media type is 1000BaseLX SFP
  input flow-control is off, output flow-control is unsupported
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input never, output never, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     194 packets input, 12786 bytes, 0 no buffer
     Received 194 broadcasts (0 multicasts)
     0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
     0 watchdog, 190 multicast, 0 pause input
     0 input packets with dribble condition detected
     245 packets output, 16130 bytes, 0 underruns
     0 output errors, 0 collisions, 3 interface resets
     0 babbles, 0 late collision, 0 deferred
     0 lost carrier, 0 no carrier, 0 PAUSE output
     0 output buffer failures, 0 output buffers swapped out

interface GigabitEthernet1/0/4
 switchport access vlan 220
 switchport mode access

Any ideas?

Regards

Mark