[f-nsp] Trunking Problem

[Dimitar Kostadinov]

On Wed, 08 Jul 2009 19:38:28 -0400

May be one of Your fiber dont work good.
1. check one by one link BI-1/1 <=> FI-1/7 and BI-1/2 <=> FI-1/8




Joseph Hardeman <jwhardeman at gmail.com> wrote:

> Hi Everyone,
> 
> I had a problem today that I am hoping someone could help me with.  I 
> went to setup trunks between a bi8000 and a fi400.  From the docs all I 
> should have had to do was run "trunk switch e 1/7 to e 1/8" on the bi 
> and "trunk switch e 1/1 to 1/2", the systems are connected via Single 
> Mode Fiber run between two floors, and then "trunk deploy" on each 
> system.  After doing this, we started getting complaints about packet 
> loss to and from our networks.  I ran show trunk on each system many 
> times and did not see any issues, there was nothing logged stating there 
> were any issues, and I did not see any errors on the individual 
> interfaces on either system.  It came to a point I had to remove the 
> trunk to get traffic to start flowing properly again.
> 
> Does anyone know what could have caused this or how I can troubleshoot 
> to see what could have caused it because I need to get this trunk up as 
> soon as I can.  As this is a live network and we are adding the 
> additional lines for capacity, I have very limited time to get this in 
> place right and today certainly didn't help. :-)
> 
> Thanks for everything.
> 
> Joe
> _______________________________________________
> foundry-nsp mailing list
> foundry-nsp at puck.nether.net
> http://puck.nether.net/mailman/listinfo/foundry-nsp
> 


-- 
 <kgb at bginfo.net>