[f-nsp] unable to add untagged port to vlan

[Joseph Jackson]

Hello,

On some FESX448's I have I am trying to add a trunk port (eth 9 to 10) to vlan 30 untagged.  

It is a tagged member of other vlans.  When trying to place them untagged into the vlan I get this error message.

SSH at lvretailfesx06(config-vlan-30)#untagged ethernet 9 to 10
error - port ethe 9 to 10 are not member of default vlan



Been going through the docs but not finding out anything with this error.




Port info

SSH at lvretailfesx06(config-vlan-30)#sh inter eth 9
GigabitEthernet9 is up, line protocol is up 
  Hardware is GigabitEthernet, address is 0012.f28d.2cc0 (bia 0012.f28d.2cc8)
  Configured speed auto, actual 1Gbit, configured duplex fdx, actual fdx
  Configured mdi mode AUTO, actual MDI
  Member of 4 L2 VLANs, port is tagged, port state is FORWARDING
  BPDU guard is Disabled, ROOT protect is Disabled
  Link Error Dampening is Disabled
  STP configured to ON, priority is level0
  Flow Control is config enabled, oper enabled, negotiation disabled
  mirror disabled, monitor disabled
  Member of active trunk ports 9-10, primary port
  Member of configured trunk ports 9-10, primary port
  No port name
  IPG MII 96 bits-time, IPG GMII 96 bits-time
  IP MTU 1500 bytes, encapsulation ethernet
  300 second input rate: 56 bits/sec, 0 packets/sec, 0.00% utilization
  300 second output rate: 4144 bits/sec, 5 packets/sec, 0.00% utilization
  51148 packets input, 21116705 bytes, 0 no buffer
  Received 1162 broadcasts, 2259 multicasts, 47727 unicasts
  0 input errors, 0 CRC, 0 frame, 0 ignored
  0 runts, 0 giants
  27329907 packets output, 2754285747 bytes, 0 underruns
  Transmitted 5554345 broadcasts, 20651264 multicasts, 1124298 unicasts
  0 output errors, 0 collisions


Thanks!

Joseph