[f-nsp] foundry-nsp Digest, Vol 88, Issue 26

[Lazuardi Nasution]

Hi Scott,

Is this ordering problem still happen after rebooting ?

I was success with previous version of firmware (v12.0), at least it
worked after rebooting. But with current firmware (v12.1) I get no
success. I have tried ip policy frag-match-source as suggested, but it
still doesn't work even after rebooting.

Best regards,

> From: "Scott T. Cameron" <routehero at gmail.com>
> To: foundry-nsp at puck.nether.net
> Date: Fri, 28 May 2010 06:47:23 -0400
> Subject: Re: [f-nsp] Route-Map Problem
> The ServerIron platform is generally very sensitive to the order of things.  I've had this exact same problem before -- and banged my head against the wall.
> However, you are missing one important thing on your config:  ip policy frag-match-source.  This will insure that all packets are treated.
>
> I'd start over, removing all the relevant PBR lines.  Enter in the ACL first, exit, write mem.  Enter in the route-map, exit, write mem.  Finally, add in the ip policy statements.
> Scott
>
> On Wed, May 26, 2010 at 12:51 PM, Lazuardi Nasution <mrxlazuardin at gmail.com> wrote:
>>
>> Dear you,
>>
>> I get some problem to do some demo of ServerIron with PBR (route-map)
>> feature. It seem that route-map command give no effect so the link
>> become fail over, not active-active. My goal is each port can have its
>> own next hop, disregard the routing table or default routes. Any
>> suggestion ?
>>
>> Best regards,
>>
>>
>> Following is the script of my configuration.
>>
>>
>> vlan 2 by port
>> untagged ethe 1
>> router-interface ve 2
>>
>> vlan 3 by port
>> untagged ethe 2
>> router-interface ve 3
>>
>> ip route 0.0.0.0 0.0.0.0 192.168.0.254 distance 10
>> ip route 0.0.0.0 0.0.0.0 192.168.255.254
>>
>> interface ve 2
>> ip address 192.168.0.1 255.255.255.0
>> ip policy route-map PBR
>>
>> interface ve 3
>> ip address 192.168.255.1 255.255.255.0
>>
>> access-list 2 permit 192.168.0.0 0.0.0.255
>> access-list 2 deny any
>>
>> route-map PBR permit 10
>> match ip address 2
>> set ip next-hop 192.168.0.254
>>
>>
>> Following is the "show version" command.
>>
>>
>> Copyright (c) 1996-2009 Brocade Communications Systems, Inc.
>> Boot Version 12.1.00T405 Oct 29 2009 10:12:19 PST label: dob12100
>> Monitor Version 12.1.00T405 Oct 29 2009 10:12:19 PST label: dob12100
>> System Version 12.1.00T403 Dec 17 2009 10:21:27 PST label: ASR12100
>> AXP Version: 1.12 Dated: 2009/12/01 10:22:32
>> PAX Version: 0.0 Dated: 2009/07/28 10:35:11
>> MBRIDGE Version: 000b, Device ID # bebe
>>
>> ==========================================================================
>> Type:  Stackable 16GC
>> Backplane Serial #:  SA19091395
>> Chassis Serial #: Not-Present
>> Part #:  46458-00DB
>> Version #: 11b626-020202ff-111d8036-00
>> ==========================================================================
>> Active management module:
>> 1499 MHz Power PC processor (version 00008021/0030) 599 MHz bus
>> 512 KB Boot flash
>> 131072 KB Code flash
>> 2048 MB DRAM
>> The system uptime is 9 minutes 39 seconds
>> The system started at 04:21:03, GMT+00, Wed May 26 2010
>>
>> The system - boot source: secondary, mode: warm startsoft reset, total
>> resets:11  soft reset, total resets:11
>>
>>
>> Following is the "show flash" command.
>>
>>
>> Active management module:
>> Compressed Pri Code size = 23321502, Version 12.1.00T401 Dec 17 2009
>> 10:08:10 PST label: ASM12100
>> Compressed Sec Code size = 24392549, Version 12.1.00T403 Dec 17 2009
>> 10:21:27 PST label: ASR12100
>> Used Configuration Flash Size=4469, Max Configuration Flash Size=1441790
>>
>> Code flash:
>> Size :  134217728 bytes
>> Bytes Used :  54544222 bytes
>> Bytes Free :  76808192 bytes
>>
>> USB 0 drive:
>> Size : 4102352896 bytes
>> Bytes Used :      4096 bytes
>> Bytes Free : 4102348800 bytes
>>
>> No external USB drive found in system