[f-nsp] Show SNMP community string configured on FastIron

[Jared Valentine]

Are you looking for something like this?

telnet at FCX(config)#show run | in community
snmp-server community ..... ro
snmp-server community ..... rw
telnet at FCX(config)#enable password-display  <<---
telnet at FCX(config)#show run | in community
snmp-server community 1 $Sa2^Zd ro
snmp-server community 1 $SUbr3o8 rw
telnet at FCX(config)#



-----Original Message-----
From: foundry-nsp-bounces at puck.nether.net
[mailto:foundry-nsp-bounces at puck.nether.net] On Behalf Of Robert Hass
Sent: Monday, August 06, 2012 12:37 PM
To: foundry-nsp at puck.nether.net
Subject: [f-nsp] Show SNMP community string configured on FastIron

Hi
Is any way to display currently configured community string on FastIron ?

I cannot display them. There is also no command like 'no service
password-encryption'

It's ICX 6450 running FastIron software 7.4.00a.

ICX6450-24 Router#show snmp server

      Contact:
     Location:
Community(ro): .....


Traps
                   Cold start: Enable
                      Link up: Enable
                    Link down: Enable
               Authentication: Enable
           MAC Authentication: Enable
     Locked address violation: Enable
         Power supply failure: Enable
                  Fan failure: Enable
                   Metro ring: Enable
              Module inserted: Enable
               Module removed: Enable
          Temperature warning: Enable
                 STP new root: Enable
          STP topology change: Enable
                         ospf: Enable
                          bgp: Enable
                         vrrp: Enable
                        vrrpe: Enable
                         vsrp: Enable
                Holddown time: 60

 Total Trap-Receiver Entries: 0
ICX6450-24 Router#sh run | inc snmp
snmp-server community ..... ro

Rob
_______________________________________________
foundry-nsp mailing list
foundry-nsp at puck.nether.net
http://puck.nether.net/mailman/listinfo/foundry-nsp