[f-nsp] NI-MLX-10Gx8-D falls to CARD_STATE_INTERACTIVE mode

[Alexander Shikoff]

Hello!

On Thu, Jun 21, 2012 at 12:12:47PM +0200, Niels Bakker wrote:
> * jeroen.wunnink at atrato-ip.com (Jeroen Wunnink | Atrato IP Networks) [Thu 21 Jun 2012, 10:35 CEST]:
> >And if that doesn't work, do a 'lp sync <linecardnumber>', it will 
> >sync the lp's flash from the one stored in the management module's 
> >flash
> 
> But what if that doesn't work for some reason, perhaps because the
> management module of this particular loaner doesn't have any LP image
> stored on its flash?
> 
> Perhaps by now we can ask the original poster for advice on what to do 
> in such a case...

Some minutes ago I upgraded IronWare both on Management module and Interface
module. But Interface module still does not boot up properly.

telnet at NetIron MLX-16 Router#show module
        Module                             Status      Ports  Starting MAC
M1 (upper): BR-MLX-MR2-M Management Module     Active
M2 (lower):
F1: NI-X-HSF Switch Fabric Module         Active
F2: NI-X-HSF Switch Fabric Module         Active
F3: NI-X-HSF Switch Fabric Module         Active
F4:
S1: NI-MLX-10Gx8-D 8-port 10GbE (D) Module  CARD_STATE_SW_LOADED        0        0024.38a1.c900
[...]

I rconsoled to slot 1. Boot process breaks at phase:
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

All TM interrupts have been cleared
Read TM recovery flash - need to use default values
TM recovery set to 1, 6 times
STATS FPGA #0 pre-init completed.
Reserving 0x01300000 bytes for data buffers, available size = 0x01400000
Reserving 0x000989c0 bytes for descriptors, available size = 0x00100000
Reserving 0x00013f00 bytes for CPU queue structure, available size = 0x00100000
pbifHashTableInit: PBIF #0 hash base address 0x08ec2000
pbifHashTableInit: PBIF #0 hash base address 0x08ec2000
pbifSessionTableInit: tower #0 session base address 0x08f13000
pbifSessionTableInit: tower #1 session base address 0x08f13000
pbif_ager_linklist_init: PBIF #0 pLinkListEntry base 0x08f24000
rw2_cpu_pkt_buf_init : rx_priority_mode set failed after 6 tries.
Module is dow
NetIron XMR/MLX Boot Monitor Version 5.3.00
Enter 'b' to stop at boot monitor

... and repeats again.

-- 
MINO-RIPE