[f-nsp] telnet issue on multiple Foundry switches

[George B.]

How many active telnet sessions do you have?  Are the previous
sessions closing completely?  This behavior sounds like what happens
when it reaches its maximum number of telnet sessions.

On Tue, May 29, 2012 at 7:31 PM,  <aaron at wholesaleinternet.net> wrote:
> Hello all,
>
> I'm having a strange issue when I try to telnet into a few of my foundry
> switches.  The switches will refuse the connections.
>
> I originally had this issue with two 4802s.  I thought the problem was due
> to bad switchs but then the issue popped up on an MG8 and an RX4.
>
> If I stop and restart the telnet service from the console they will accept
> telnet connections for about 5 minutes, then start refusing them again.
> show telnet shows no active sessions and the CPUs are not overloaded. Logs
> are clear.
>
> Has anyone experienced this before and knows a solution?  Is this a known
> issue I need to look out for?  Any advise is appreciated.
>
> Aaron
>
> _______________________________________________
> foundry-nsp mailing list
> foundry-nsp at puck.nether.net
> http://puck.nether.net/mailman/listinfo/foundry-nsp