[f-nsp] vlan byte-accounting issue on big iron rx

[Audrius Peciukas]

it gets "enabled" with that error message and shows in config but does not
do actual accounting, none vlan byte accounting works

using these cards: RX-BI-24F 24-port 1 GbE Module  CARD_STATE_UP    24

some vlans span over couple cards but most of them are on one 1st card

AJ





On Thu, Nov 7, 2013 at 7:54 PM, Kennedy, Joseph <Joseph.Kennedy at purchase.edu
> wrote:

>  Are you saying you can’t even enable it on a single vlan or that you have it enabled on some
>
> but can’t enable it on all the vlans you want to?
>
>
> What model line cards are you using?
>
> Is the vlan in question spanning different models of line cards?
>
> --JK
>
> >* Hi all,
> *>>* im using big iron rx (2.9 firmware) and trying to enable byte-accounting
> *>* on vlans and im getting this:
> *>>* (config-vlan-201)#byte-accounting
> *>* Error: Maximum burst cannot be greater than 1,250,000,000 bytes.
> *>>* i do not have rate limiting setup nor its for default vlan or anything,
> *>* its actually doing the same thing on all vlans
> *>>* Thanks!
> *>>* AJ
> *>
>
>
>
> _______________________________________________
> foundry-nsp mailing list
> foundry-nsp at puck.nether.net
> http://puck.nether.net/mailman/listinfo/foundry-nsp
>



-- 

Audrius Peciukas
1Wire Communications
http://www.1wirecom.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/foundry-nsp/attachments/20131107/145dab1e/attachment.html>