[f-nsp] IPv6 support on FESX648-PREM

[ebradsha at gmail.com]

Hello,

We have a FESX648-PREM that I'd like to use to announce an IPv6 range. It
was my understanding that the FESX648-PREM supported IPv6, but I can't seem
to enter the IPv6 section of my BGP config:

SSH at FESX648 Router(config-bgp-router)# address-family ipv6 unicast
Invalid input -> address-family ipv6 unicast
Type ? for a list
SSH at FESX648 Router(config-bgp-router)#


My router version info is as follows:

SSH at FESX648 Router(config-bgp-router)#show version
  SW: Version 07.4.00eT3e3 Copyright (c) 1996-2012 Brocade Communications
Systems, Inc. All rights reserved.
      Compiled on Dec 11 2013 at 19:00:43 labeled as SXR07400e
      (4593059 bytes) Primary sxr07400e.bin
      BootROM: Version 07.2.00T3e5 (FEv2)
  HW: Stackable FESX648-PREM6 (PROM-TYPE FESX648-L3U-IPV6)
==========================================================================
      Serial  #: XXXXXXXX
         License: SX_V6_HW_ROUTER_IPv6_SOFT_PACKAGE   (LID: XXXXXXXXXX)
      P-ASIC  0: type 0111, rev 00  subrev 01
      P-ASIC  1: type 0111, rev 00  subrev 01
      P-ASIC  2: type 0111, rev 00  subrev 01
      P-ASIC  3: type 0111, rev 00  subrev 01
==========================================================================
  300 MHz Power PC processor 8245 (version 0081/1014) 66 MHz bus
  512 KB boot flash memory
 8192 KB code flash memory
  256 MB DRAM
The system uptime is 23 days 13 hours 55 minutes 37 seconds
The system : started=cold start


Is BGP4+ not supported on the FESX648-PREM?

- Elliot
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/foundry-nsp/attachments/20140630/8b2fc50f/attachment.html>