[f-nsp] IPv6 support on FESX648-PREM

[Jeff McAdams]

Just use "address-family ipv6"

Leave off the unicast.  Probably a bug there, but is mostly harmless.

Works great once you figure that little oddity out.

On Mon, June 30, 2014 20:33, ebradsha at gmail.com wrote:
> Hello,
>
>
> We have a FESX648-PREM that I'd like to use to announce an IPv6 range. It
>  was my understanding that the FESX648-PREM supported IPv6, but I can't
> seem to enter the IPv6 section of my BGP config:
>
> SSH at FESX648 Router(config-bgp-router)# address-family ipv6 unicast
> Invalid input -> address-family ipv6 unicast
> Type ? for a list
> SSH at FESX648 Router(config-bgp-router)#
>
>
>
> My router version info is as follows:
>
>
> SSH at FESX648 Router(config-bgp-router)#show version
> SW: Version 07.4.00eT3e3 Copyright (c) 1996-2012 Brocade Communications
> Systems, Inc. All rights reserved.
> Compiled on Dec 11 2013 at 19:00:43 labeled as SXR07400e
> (4593059 bytes) Primary sxr07400e.bin
> BootROM: Version 07.2.00T3e5 (FEv2)
> HW: Stackable FESX648-PREM6 (PROM-TYPE FESX648-L3U-IPV6)
> ==========================================================================
>  Serial  #: XXXXXXXX
> License: SX_V6_HW_ROUTER_IPv6_SOFT_PACKAGE   (LID: XXXXXXXXXX)
> P-ASIC  0: type 0111, rev 00  subrev 01
> P-ASIC  1: type 0111, rev 00  subrev 01
> P-ASIC  2: type 0111, rev 00  subrev 01
> P-ASIC  3: type 0111, rev 00  subrev 01
> ==========================================================================
>  300 MHz Power PC processor 8245 (version 0081/1014) 66 MHz bus
> 512 KB boot flash memory
> 8192 KB code flash memory
> 256 MB DRAM
> The system uptime is 23 days 13 hours 55 minutes 37 seconds
> The system : started=cold start
>
>
>
> Is BGP4+ not supported on the FESX648-PREM?
>
>
> - Elliot
> _______________________________________________
> foundry-nsp mailing list foundry-nsp at puck.nether.net
> http://puck.nether.net/mailman/listinfo/foundry-nsp


-- 
Jeff