dx-60 one down, one to go

[GREGORY HEATH]

I fixed the squeal in the dx-60.  It was the trailing off of the carrier
when I selected 'stand-by' from the 'AM' position.  Apparently the  small
yellow wire from the 470k ohm resistor and "power on light"  had broken and
laid itself down behind a screw.  I reattached it to the 110V/30ma secondary
wire which now allows the "power-on light" and the -130v line to come
together.  Now the rig turns to standby without the 6 second fading of the
carrier to off.  It is now clean.
    The only problem I now face, is that I have a carrier, but no
modulation.  I can transmit a clean cw note, but when I hook up the  D-104,
there is no voice on the carrier.  Back to the drawing board.  The rig loads
up fine.  Maybe it is one of the tubes.   Although I just replaced them.
Any ideas?  Greg.

--- --- --- --- --- --- --- --- --- --- --- --- --- --
To subscribe: listserv at listserv.tempe.gov
and in body: subscribe HEATH yourfirstname yourlastname
To unsubscribe:  listserv at listserv.tempe.gov
and in body: signoff HEATH
Archives for HEATH: http://www.tempe.gov/archives
--- --- --- --- --- --- --- --- --- --- --- --- --- --