Sb102 Problem

[Ray A. Allen, Sr.]

Group,
 Thanks to those who have been folowing this adventure.

So I decided to go back to square one. Disconnected all the cables,
flipped thru the book to the "Resistance Chart", figureing I'd do
all the resistances first...
I figure this problem of Half power out got to be in PA section some
place, so I start there.  Pin 3 V8 and V9, book says 95k. OK they
be tied with a heavy wire, so shud be the same, so I measure..
220 k ...what shud be 95, so the book says.......check the schematic
and there is a 220k resistor hanging off the "bus" wire from V8 to
V9 and it goes to ground.....

Q. Why would the book indicate 95k at pin 3 V8/V9 when a 220K resistor
connects them to chassis..

I never was smart at this stuff...;o))))

es 73 Ray
--
******************************
Ray A. Allen, Sr., W2KBR/3
8303 Grainfield Rd.,
Severn, Maryland, 21144-2331
******************************

--- --- --- --- --- --- --- --- --- --- --- --- --- --
To subscribe: listserv at listserv.tempe.gov
and in body: subscribe HEATH yourfirstname yourlastname
To unsubscribe:  listserv at listserv.tempe.gov
and in body: signoff HEATH
Archives for HEATH: http://www.tempe.gov/archives
--- --- --- --- --- --- --- --- --- --- --- --- --- --