SB200 Help

[Joel Miller]

There is a terminal strip on which the the power cord's wires are connected.
When set up for 240V operation, there is a single jumper wire between screw
terminals #2 and #3 on this strip.

Operation for 120V is accomplished by removing this jumper and connecting it
between screw terminals #1 and #2, and adding an additional jumper between
screw terminals #3 & #4.

Keep in mind the SB-200 runs more efficiently on 240V however, and that the
load at full power at 120V is 16A!

73
Joel
W7PDX

>> From: Mike P. Bellow <mike-7 at JUNO.COM>

>> To: HEATH at LISTSERV.TEMPE.GOV

>> Subject: SB200 Help

>> Date: January 21, 1999 8:29 PM

>>

>> Hello I have a used SB200 amp wired for 220 volts and I would like to

>> wire it for 110 volt.A nd I don't have a manual for this amp.Is it

>> possible to change it to 110????And could someone E-MAIL me and explain

>> how to do it????

>> thanks Mike

>> MIKE-7 at juno.com

--- --- --- --- --- --- --- --- --- --- --- --- --- --
To subscribe: listserv at listserv.tempe.gov
and in body: subscribe HEATH yourfirstname yourlastname
To unsubscribe:  listserv at listserv.tempe.gov
and in body: signoff HEATH
Archives for HEATH: http://www.tempe.gov/archives
--- --- --- --- --- --- --- --- --- --- --- --- --- --