FW: HW-101 step 4

[Jordan Arndt]

Clark, John wrote:
>
> Doug, I'm looking at your suggestions.
>
> This oscillator has two stages, the A & B side of a 12AT7.
>
> The crystals and DC test point are on grid of the first stage.
> The plate of this first side is tuned by the second wafer of the
> select switch.  The first 3 with L&C, and next 5 with only L.
>
> The plate output is then Cap coupled to the B side grid. I think this B
> side is called a "Cathode Follower"
>
> The output is taken from the Cathode of the B side via a 100 uuf cap.
>
> I took my frequency readings from the far side of this Cap, heading to
> the
> "Second transmitter mixer and to the first receiver mixer"
>
> To follow your suggestion I lifted the DVM from the test point while
> watching the frequency,
> no change.
>
> Unfortunately the KB9JJA web page does not have the schematic for this
> radio listed.
>
> Your comments have been so helpful, I would like to send you a copy to
> help me along.
>
> Got a FAX?
>
>     ---------------------------------------------------------------
>
> Subject: Re: FW: HW-101 step 4
> Date: Thu, 13 May 1999 07:21:00 -0600
> From: "k5cr at juno.com" <k5cr at juno.com>
> To: "john.clark at STATE.CO.US" <john.clark at STATE.CO.US>
>
> John:
>
> The freq of the crystals is changing due to the plate load impedance
> changing as you tune the oscillator coils.   I see that they all look to
> be on the low freq. side of the stated crystal freq.   Is there a chance
> the freq counter is loading the oscillator and shifting the freq down??
> It is possible that when you disconnect the freq counter the osc. freq
> is
> going up.
>
> I would set the tuning to 80 to 90 percent of the peak grid voltage and
> let it go.   The way to tune the crystals on freq would be by changing
> the oscillator load cap. (reducing the capacitance that the crystal).
> Usually as the crystal ages the freq goes up but I see that your list
> showes they are lower than the marked freq.  This makes me think the
> freq
> counter is loading the oscillator.
>
> Hope this helps.
>
> 73
>
> Doug/K5CR
> ___________________________________________________________________
> You don't need to buy Internet access to use free Internet e-mail.
> Get completely free e-mail from Juno at http://www.juno.com/getjuno.html
> or call Juno at (800) 654-JUNO [654-5866]


P.S> after looking at your posts regarding the frequency set with the
best setting for the oscillator, I see that most of your frequencies are
WELL within "Normal"... Heath never intended the rigs to be accurate to
within 10 hz... if they hasd, they would have designed the Readout as
such... the worst case offset I see is 2.7 khz on 80 meters, and 2 of
the 10 meter portions... this is very reasonable... and expected... 73
de Jordan...

--- --- --- --- --- --- --- --- --- --- --- --- --- --
To subscribe: listserv at listserv.tempe.gov
and in body: subscribe HEATH yourfirstname yourlastname
To unsubscribe:  listserv at listserv.tempe.gov
and in body: signoff HEATH
Archives for HEATH: http://www.tempe.gov/archives
--- --- --- --- --- --- --- --- --- --- --- --- --- --