SB-102 S Meter

[Ed Richards]

Mark;
Check the AVC voltage. It might be decaying too slowly. Open resistor,
maybe. Good luck.
Ed Richards

On Wed, 5 Apr 2000 21:44:07 -0400 Mark Adams <madams0 at US.IBM.COM> writes:
> Hello to all
>
>
> From: Mark Adams at IBMUS on 04/05/2000 09:44 PM
>
>
> To:   HEATH at LISTSERV.TEMPE.GOV
> cc:
> Subject:  SB-102 S Meter
>
> I have a SB-102 that is giving me a hard time with the S meter.
>
> I can zero set the S-meter and it stays right on the zero.  when
> receiving
> strong signals for awhile and place the unit on a dummy load the
> S-meter
> will be at 3 s-units, after awhile it will slowly rest at the zero
> mark.
>
> I have re-tubed this unit and replaced any suspecting resistors in
> the
> unit, per the manual and all updates available.
>
> I have seen the fix for this and have taken the actions but still
> have this
> problem.
>
> Any comments/advice would be appreciated.
>
> Take care, Mark
>
> Heath HF gear lives on
>
> Sponsored by the City of Tempe
>
> Listserver Submissions:  heath at listserv.tempe.gov
> Listserver Subscription: listserv at listserv.tempe.gov - "subscribe
> heath 'name' 'call'"
> Listserver Unsubscribe: listserv at listserv.tempe.gov - -"signoff
> heath"

Sponsored by the City of Tempe 

Listserver Submissions:  heath at listserv.tempe.gov
Listserver Subscription: listserv at listserv.tempe.gov - "subscribe heath 'name' 'call'"
Listserver Unsubscribe: listserv at listserv.tempe.gov - -"signoff heath"