Cause of S-Meter resolution

[Mark Adams]

Hello


From: Mark Adams at IBMUS on 04/12/2000 11:09 PM


To:   HEATH at LISTSERV.TEMPE.GOV
cc:
Subject:  Cause of S-Meter resolution

I finally found the cause of my S-meter problem.  It turned out to be a bad
tube socket(V3).  I noticed this when switching out the tubes to see if it
would help.

I replaced the tube socket and the S-meter is working just fine.
It was sticking at around S-3 and then falling down to s-0 or below  s-0
after 10 minutes.  It also stuck at S-3 after transmitting for awhile and
then fell below S-0 after about 10 minutes.

Take care, and thanks for all the help.

Mark D. Adams

Heath HF gear lives on

Sponsored by the City of Tempe 

Listserver Submissions:  heath at listserv.tempe.gov
Listserver Subscription: listserv at listserv.tempe.gov - "subscribe heath 'name' 'call'"
Listserver Unsubscribe: listserv at listserv.tempe.gov - -"signoff heath"