ho-10 problems

[charles w. morehouse]

Kevin,
Have restored two HO-10's and two HO-13's. The 1V2 is suspect. Also
replace the two HV caps and any high value resistors around the CRT.
The caps are hard to find  but you can use two .05 caps in parallel at
1600V . You can get these Orange drops at Antique Electronic Supply.
Have also had to replace the 1V2 socket. Use ceramic if possible. Hope
the tranny is OK. Peter Dahl gets $150 a pop for them. Bottom
line..replace all. Good luck and 73.
Wayne;
W4GBW
kevin smith wrote:
>
> i have a heathkit ho-10 that was working fine until last night,smoke
> started to come out of it,i opened it up,and found under the 1v2 tube a
> resistor burned out 220k ohms, i replaced it and it smoked up,plus i
> replaced the 500 k pot linear control on the hor.switch it was arking
> inside of it, its still doing it, all the tubes light up , do not know
> alot about what to look for any help on this one?----kevin