Fw: SB 101 MIC IMPEDANCE??

[talen]

I've always checked a "high impedance" mike's output capability by
measuring it's output at the connector into the mike circuit and look for
at least 150mv Peak to Peak at about 1 Khz from the mike
....that should be sufficient.

73s  Kees K5BCQ

----------
From: Rob Ellis <ac6wq at YAHOO.COM>
To: HEATH at LISTSERV.TEMPE.GOV
Subject: SB 101 MIC IMPEDANCE??
Date: Wednesday, June 21, 2000 12:45 PM

Hi all, I have SSB xmit trouble . Rig was tested ok on
SSB by previous owner whom I know to be reliable.  I
wired up my "flea market" Electro Voice mic per the
book and had about 4-5 watts RF output. I'm suspect
that I have the wrong impedance mic.  What is
considered high impedance? For example I have an old
Yaesu mic that's marked 600 ohm, is that high
impedance?  Your comments appreciated. Rob

=====
"There Is No Better Fun To Be Had Then Sitting In The Radio Shack On A Cold Winter Evening DXing with a Heathkit"

Listserver Subscription:listserv at listserv.tempe.gov - "subscribe heath 'name' 'call'"
Listserver Submissions: heath at listserv.tempe.gov
Listserver Unsubscribe: listserv at listserv.tempe.gov - -"signoff heath"

Listserver Subscription:listserv at listserv.tempe.gov - "subscribe heath 'name' 'call'"
Listserver Submissions: heath at listserv.tempe.gov
Listserver Unsubscribe: listserv at listserv.tempe.gov - -"signoff heath"