hg10 vfo/dx60b

[Mark S Graalman]

  Dan, the HG-10 output is VERY sensitive to any
loading, you must use a low capacitance cable on the VFO
output such as RG-62. I have used RG-58 but it will only
work if the total length is 1 foot or less.
 If you can, place a 50K ohm load across the VFO output
and you should measure about 3 volts RMS, if the
VFO output is up to snuff and the output cable is ok
I would check the xtal/vfo switch.

Mark  WB8JKR


On Wed, 8 Mar 2000 14:09:35 -0330 Dan Toohey <k1yzb at GIS.NET> writes:
> Need some help with   HG10 driving  DX60B..
>
>
> The drive tune and drive level work fine when in crystal position.
> Plenty of drive to final amp,good output..Every thing works as it
> should...
>
> How ever when I switch to VFO I lose  all grid drive ,there is no
> indication on meter when I try to adjust drive tune and drive
> level..
>
> The VFO is running,   I can hear it in the receiver.
>
> Question is why no grid drive when in VFO position ??
>
> Any and all help or suggestions will be appreciated
>
> Thanks very much.. Dan K1yzb

Sponsored by the City of Tempe 

Listserver Submissions:  heath at listserv.tempe.gov
Listserver Subscription: listserv at listserv.tempe.gov - "subscribe heath 'name' 'call'"
Listserver Unsubscribe: listserv at listserv.tempe.gov - -"signoff heath"