MATCHING TRANSFORMER

[Ed Richards]

Ralph;

Those are scarce as hen's teeth. I have been faced with the same problem
and solved it by using a Radio Shack line matching transformer #
32-1031, rated for 10 watts. They also have a 100 watt model. When I was
the radioman on Noah's Ark, the standard line impedance was 500 ohms. Now
it is 70 volt. I don't know the relationship between the two. I would
love to know. Perhaps someone can enlighten me. While they don't indicate
an impedance, the transformer has several high impedance primary taps and
several low impedance secondary taps labeled 4, 8 and 16 ohms. Since
there is a rule that maximum energy is transferred when the impedances
are matched, I do the following: temporarily connect the speaker to the C
and 4 ohm lugs and try all the primary taps for the loudest volume. Then
try all the secondary taps for the loudest volume. Repeat this again. You
will notice when you do this the tonal quality will change. If the volume
is similar, you can select the tap that gives the most pleasing tone. I
have a Hallicrafters SX-28 operating on one right now. I am using the
2.5W primary tap and the 4 ohm secondary tap. I hope this helps.

Ed Richards

On Sat, 11 Nov 2000 10:05:26 -0600 "Ralph L. Hopkins" <rh84859 at NAVIX.NET>
writes:
> ANY ONE ON THIS LIST HAVE A 4 OHM TO 500 OHM AUDIO
> TRANSFORMER.  I NEED ONE FOR A PHONE PATCH.
> TKS
> HOPPY W4YDN
>
> Listserver Subscription:listserv at listserv.tempe.gov - "subscribe
> heath 'name' 'call'"
> Listserver Submissions: heath at listserv.tempe.gov
> Listserver Unsubscribe: listserv at listserv.tempe.gov - -"signoff
> heath"

Listserver Subscription:listserv at listserv.tempe.gov - "subscribe heath 'name' 'call'"
Listserver Submissions: heath at listserv.tempe.gov
Listserver Unsubscribe: listserv at listserv.tempe.gov - -"signoff heath"