SB-400/401 P.S. TRANSFORMER Specs...

[Eddy Swynar]

Hi Keith...

Many thanks for the info re. the voltage/current available from this
transformer...

I hope you don't mind, but I'm "C.C.'ing" your response to the Reflector,
for benefit of others.

Thanks, as well, to those others who took the time to respond to my call for
help! Much appreciated...

~73~ Eddy VE3CUI - VE3XZ




----- Original Message -----
From: "k4kgw" <k4kgw at mediaone.net>
To: "Eddy Swynar" <gswynar at DURHAM.NET>
Cc: <HEATH at LISTSERV.TEMPE.GOV>
Sent: Sunday, March 11, 2001 11:48 AM
Subject: Re: SB-400/401 P.S. TRANSFORMER Specs...


> Hi Eddy,
>
> Red and Red Yellow:  This winding is used with a diode voltage-doubler to
provide 720V @ 250 ma.
>
> The brown winding goes to the bias supply (-150V with no load).
> Blue:  Ground (Earth).
> Brown/Yellow:  95V @ 160 ma.
> These three leads are actually one winding.  Brown is one end, Blue the
other end, and Brown/Yellow the center tap.
>
> Two Yellow: 12.6VAC, center-tapped.  (6.20VAC either side of center tap).
Crrent available from these is not specified, but if you add up all the
rated filament draw of all the
> tubes in the rig and add one or two amps, you will be close enough.
>
> 73,
>
> Keith
>
> Eddy Swynar wrote:
>
> > Greetings All...
> >
> > Can anyone provide me with the actual specifications (including current
draw) for the power supply *transformer* as was utilized internally by the
SB-400/401 transmitters...?
> >
> > Many thanks in advance...
> >
> > ~73~ Eddy VE3CUI - VE3XZ
> >
> > ----- Original Message -----
> >   From: Eddy Swynar
> >   To: HEATH at LISTSERV.TEMPE.GOV
> >   Sent: Sunday, January 21, 2001 3:52 PM
> >   Subject: Dial Driver For "SB" Rigs...
> >
> >   Many thanks to all who responded to my call re. the repair and/or
replacement of this critical part of the "SB" line...
> >
> >   I received some EXCELLENT suggestions, AND the kind offer of a
replacement unit.
> >
> >   MANY THANKS again!
> >
> >   ~73~ Eddy VE3CUI - VE3XZ
> >
> > Listserver Subscription:listserv at listserv.tempe.gov - "subscribe heath
'name' 'call'"
> > Listserver Submissions: heath at listserv.tempe.gov
> > Listserver Unsubscribe: listserv at listserv.tempe.gov - -"signoff heath"
>
>
>

Listserver Subscription:listserv at listserv.tempe.gov - "subscribe heath 'name' 'call'"
Listserver Submissions: heath at listserv.tempe.gov
Listserver Unsubscribe: listserv at listserv.tempe.gov - -"signoff heath"