HW-16 power supply rebuild
Dave Edwards
ham at CYBERCOMM.NET
Sun Jan 20 12:05:54 EST 2002
That is more than close enough!
...Dave
----- Original Message -----
From: "Gareth Gammon" <ggammon at QLYNX.COM>
To: <HEATH at LISTSERV.TEMPE.GOV>
Sent: Saturday, January 19, 2002 9:37 PM
Subject: HW-16 power supply rebuild
> The power supply on my HW-16 finally gave up; R206, a
> 220ohm 2w resistor burned clean through and probably took
> two sections of the main filter cap with it. I am planning
> on replacing all the high wattage resistors in the high
> voltage section and the filter caps. My problem is the
> filter caps. I am going to use modern axial caps and leave
> the can in place but disconnected however I can only come
> close the original values. There were 4 sections to the can;
> two 80mfd sections as well as a 40 and a 50mfd section. I
> can get 100mfd caps to replace the 80's and thought about
> using 47mfds for the 40 and 50mfd sections. All caps will
> be rated at 450v. There don't seem to be too many choices of
> values in high voltage caps these days and putting two in
> parallel doesn't really solve the problem either.
>
> I'll also have to check out the rectifier diodes and may be
> back for cross reference info. All the parts list says is
> they are silicon diodes and gives a part number.
>
> Does anyone see a potential serious problem in substituting
> the values I mentioned?
>
> Thanks for any help. 73
>
> Gareth Gammon VE7CGG
>
> -----------------------------------------------------------
> This list is a public service of the City of Tempe, Arizona
> -----------------------------------------------------------
>
> Subscription control - http://www.tempe.gov/lists/control.asp?list=HEATH
> To post - HEATH at LISTSERV.TEMPE.GOV
> Archives - http://interactive.tempe.gov/archives/HEATH.html
>
-----------------------------------------------------------
This list is a public service of the City of Tempe, Arizona
-----------------------------------------------------------
Subscription control - http://www.tempe.gov/lists/control.asp?list=HEATH
To post - HEATH at LISTSERV.TEMPE.GOV
Archives - http://interactive.tempe.gov/archives/HEATH.html
More information about the Heath
mailing list