Replacement Finals??

[Jerry Forwood]

You might also look at the driver and other tubes in front of the finals.
 The finals can not amplify to max output if the drive into them is not
up to specs.
73 de Jerry, KØEJF.

On Wed, 3 Sep 2003 18:35:19 +0000 wb7tne at COMCAST.NET writes:
>  Hello all. Say,what are the best available final replacement tubes
> on the
> market for the HW-100. Althought this radio has seen little use,and
> I've been
> able to go throught the complete alignment process,receiver and
> transmitter
> both,the output is 60-80 watts on 15-10.Seems ok there.Then it's
> down to 40 on
> 20 meters. 80-40 is ten to 20 watts and falls off after about 10
> seconds of
> keying.Heterodyne crystals weak or bad?? This is all into a known
> good dummy
> load. Any suggestions would be appreciated. Thanks to the
> list.Driver tube is
> good.
>
> 73
> Daryle
> WB7TNE
>
> -----------------------------------------------------------
> This list is a public service of the City of Tempe, Arizona
> -----------------------------------------------------------
>
> Subscription control -
> http://www.tempe.gov/lists/control.asp?list=HEATH
> To post - HEATH at LISTSERV.TEMPE.GOV
> Archives - http://interactive.tempe.gov/archives/HEATH.html
>
>


73 de Jerry, KØEJF

-----------------------------------------------------------
This list is a public service of the City of Tempe, Arizona
-----------------------------------------------------------

Subscription control - http://www.tempe.gov/lists/control.asp?list=HEATH
To post - HEATH at LISTSERV.TEMPE.GOV
Archives - http://interactive.tempe.gov/archives/HEATH.html