[j-nsp] compact flash failure?
Harry Reynolds
harry at juniper.net
Thu May 8 14:26:32 EDT 2003
If the second supply is installed, but does not have AC/DC power
coming into it, you will see an alarm. If you pull the supply out the
alarm will clear (it might turn yellow until you reboot with the
supply removed).
When you boot from the PCMCIA card it should reformat the flash and
lay down a new file system/JUNOS. Are you seeing any errors during
the boot from PCMCIA process? Note that one you have booted from
PCMCIA, the router will normally reboot and use the flash, or failing
that, from alternative media (the HD). From the below it does seem
that you have bad flash as the HD is being used. You may want to open
a support case, as I believe there is a flash format procedure that
*might* resurrect the RE; else you are probably looking at an RMA.
You might try a request system snapshot; this will, in theory, write
the binary environment from the boot device (the HD in your case)
back to the alternative media (which in your case is now the flash
memory. Also, have you tried a reboot specifying the boot device as
the flash?
lab at r5# run request system reboot media ?
Possible completions:
compact-flash Standard boot off flash device
disk Boot off hard disk
HTHs.
> -----Original Message-----
> From: juniper-nsp-bounces at puck.nether.net
> [mailto:juniper-nsp-bounces at puck.nether.net]On Behalf Of
> Joshua Sahala
> Sent: Thursday, May 08, 2003 12:57 PM
> To: juniper-nsp at puck.nether.net
> Subject: [j-nsp] compact flash failure?
>
>
> hello all,
>
> i am currently evaluating a m20 and am wondering what sort
> of a problem
> i have (i know, i have a lot ;) ). the device has not yet
> undergone
> recertification (and i frankly don't want to pay for that
> if i have prior
> hardware issues).
>
> my first issue: the router is showing a fault on the
> power supply. i do
> only have one p/s connected right now, so i do not know if
> that is the
> the cause.
>
> second issue: the initial boot was fine, i rebooted the
> router (after
> performing a password-recovery) and the compact flash
> seems to have
> disappeared. the router will only boot to the pcmcia or hdd.
>
> i am a juniper newbie, so i am not sure what info will be
> useful, so if
> i missed something, please tell me.
>
> thanks
>
> joshua
>
> root> show system storage
> Filesystem 1K-blocks Used Avail Capacity Mounted on
> /dev/wd1s1a 72703 50585 16302 76% /
> mfs:37 762991 1 701951 0% /tmp
> /dev/wd1s1e 17311 17 15910 0% /config
> procfs 4 4 0 100% /proc
> /dev/wd1s1f 7156052 77712 6505856 1% /var
>
> root> show chassis alarms
> 5 alarms are currently active
>
> Alarm time Class Description
>
> 2003-05-08 05:21:39 PDT Major Power Supply B 2.5 volt
> output failed
> 2003-05-08 05:21:39 PDT Major Power Supply B 5 volt output failed
> 2003-05-08 05:21:39 PDT Major Power Supply B 3.3 volt
> output failed
> 2003-05-08 05:21:39 PDT Major Power Supply B fan failed
> 2003-05-08 05:21:39 PDT Major Power Supply A fan failed
>
> root> show chassis craft-interface
>
> Red alarm: LED on, relay on
> Yellow alarm: LED off, relay off
> Host OK LED: On
> Host fail LED: Off
>
> FPCs 0 1 2 3
> -------------------
> Green * * * *
> Red . . . .
>
> LCD screen:
> +--------------------+
> | |
> |5 Alarms active |
> |R: Supply B 2v FAIL |
> |R: Supply B 5v FAIL |
> +--------------------+
>
> root> show system boot-messages
> Copyright (c) 1992-1998 FreeBSD Inc.
> Copyright (c) 1996-2000 Juniper Networks, Inc.
> All rights reserved.
> Copyright (c) 1982, 1986, 1989, 1991, 1993
> The Regents of the University of California. All
> rights reserved.
>
> JUNOS 4.4R3.4 #0: 2001-08-04 03:34:09 UTC
>
> builder at tiamat.juniper.net:/build/tiamat-a/4.4R3.4/release_
> kernel/sys/compile/GENERIC
> CPU: Pentium Pro (331.71-MHz 686-class CPU)
> Origin = "GenuineIntel" Id = 0x66a Stepping=10
>
> Features=0x183f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,M
> TRR,PGE,MCA,CMOV,<b16>,<b17>,
> MMX,<b24>>
> real memory = 805306368 (786432K bytes)
> avail memory = 785973248 (767552K bytes)
> Teknor CPU Card Recognized -- BIOS Version: 0.9
> Installed Teknor I2C driver
> Probing for devices on PCI bus 0:
> chip0 <generic PCI bridge (vendor=8086 device=7192
> subclass=0)> rev 2 class
> 60000 on pci0:
> 0:0
> chip1 <Intel 82371AB PCI-ISA bridge> rev 2 class 60100 on pci0:7:0
> chip2 <Intel 82371AB IDE interface> rev 1 class 10180 on pci0:7:1
> chip3 <Intel 82371AB USB interface> rev 1 class c0300 int
> d irq 11 on
> pci0:7:2
> smb0 <Intel 82371AB SMB controller> rev 2 class 68000 on pci0:7:3
> pcic0 <TI PCI-1251 PCI-CardBus Bridge> rev 0 class 60700
> int a irq 15 on
> pci0:13:0
> TI1251 PCI Config Reg: [pci only]
> pcic1 <TI PCI-1251 PCI-CardBus Bridge> rev 0 class 60700
> int b irq 7 on
> pci0:13:1
> TI1251 PCI Config Reg: [pci only]
> fxp0 <Intel EtherExpress Pro 10/100B Ethernet> rev 8 class
> 20000 int a irq 7
> on pci0:16:0
> chip4 <generic PCI bridge (vendor=1011 device=0022
> subclass=4)> rev 6 class
> 60400 on pci0:
> 17:0
> fxp1 <Intel EtherExpress Pro 10/100B Ethernet> rev 8 class
> 20000 int a irq 10
> on pci0:19:0
> Probing for devices on PCI bus 1:
> Probing for devices on the ISA bus:
> sc0 at 0x60-0x6f irq 1 on motherboard
> sc0: EGA color <16 virtual consoles, flags=0x0>
> ed0 not found at 0x300
> ed1 not found at 0x280
> ed2 not found at 0x340
> psm0 not found at 0x60
> sio0 at 0x3f8-0x3ff irq 4 flags 0x20010 on isa
> sio0: type 16550A, console
> sio1 at 0x3e8-0x3ef irq 5 flags 0x20000 on isa
> sio1: type 16550A
> sio2 at 0x2f8-0x2ff irq 3 flags 0x20000 on isa
> sio2: type 16550A
> sio3 not found at 0x2e8
> pcic0 at 0x3e0-0x3e1 on isa
> PC-Card ctlr(0) Intel 82365DF (5 mem & 2 I/O windows)
> pcic0: slot 0 controller I/O address 0x3e0
> pccard: card inserted
> pccard: enabled SunDisk SDP 5/3 0.6 on slot 0
> npx0 flags 0x1 on motherboard
> npx0: INT 16 interface
> fdc0: direction bit not set
> fdc0: cmd 3 failed at out byte 1 of 3
> fdc0 not found at 0x3f0
> wdc0 at 0x1f0-0x1f7 irq 14 on isa
> wdc0, unit 0 not attached, missing in Boot List
> wdc0: unit 1 (wd1): <IBM-DARA-212000>
> wd1: 8063MB (16514064 sectors), 16383 cyls, 16 heads, 63
> S/T, 512 B/S
> wdc1 not found at 0x170
> wdc2 at 0x180-0x187 flags 0x200 on isa
> wdc2: unit 0 (wd4): <SanDisk SDP3B-110>, single-sector-i/o
> wd4: 105MB (215040 sectors), 3360 cyls, 2 heads, 32 S/T, 512 B/S
> ep0 not found at 0x300
> ----
> ---- NOTICE: Booting from Alternate Media: Hard Disk
> ----
> changing root device to wd1s1a
> fxp0: Ethernet address 00:a0:a5:12:2e:49
> fxp1: Ethernet address 00:a0:a5:12:2e:48
> swapon: adding /dev/wd1s1b as swap device
> Automatic reboot in progress...
> /dev/rwd1s1a: clean, 22117 free (61 frags, 2757 blocks,
> 0.1% fragmentation)
> /dev/rwd1s1e: clean, 17294 free (14 frags, 2160 blocks,
> 0.1% fragmentation)
> /dev/rwd1s1a: clean, 22117 free (61 frags, 2757 blocks,
> 0.1% fragmentation)
> /dev/rwd1s1f: clean, 7078382 free (374 frags, 884751 blocks, 0.0%
> fragmentation)
>
> root> show version
> Hostname:
> Model: m20
> JUNOS base [4.4R3.4] (Export restricted edition)
> JUNOS Kernel Software Suite [4.4R3.4]
> JUNOS Routing Software Suite [4.4R3.4]
> JUNOS Packet Forwarding Engine Support [4.4R3.4]
> JUNOS Online Documentation Files [4.4R3.4]
> KERNEL 4.4R3.4 #0 built by builder on 2001-08-04 03:34:09 UTC
> MGD release 4.4R3.4 built by builder on 2001-08-04 04:03:37 UTC
> CLI release 4.4R3.4 built by builder on 2001-08-04 04:03:41 UTC
> CHASSISD release 4.4R3.4 built by builder on 2001-08-04
> 03:36:54 UTC
> DCD release 4.4R3.4 built by builder on 2001-08-04 03:34:16 UTC
> RPD release 4.4R3.4 built by builder on 2001-08-04 03:59:38 UTC
> SNMPD release 4.4R3.4 built by builder on 2001-08-04 03:35:14 UTC
> MIB2D release 4.4R3.4 built by builder on 2001-08-04 03:35:20 UTC
> APSD release 4.4R3.4 built by builder on 2001-08-04 03:36:33 UTC
> VRRPD release 4.4R3.4 built by builder on 2001-08-04 03:36:37 UTC
> ALARMD release 4.4R3.4 built by builder on 2001-08-04 03:36:48 UTC
> PFED release 4.4R3.4 built by builder on 2001-08-04 03:37:34 UTC
> CRAFTD release 4.4R3.4 built by builder on 2001-08-04 03:37:30 UTC
> SAMPLED release 4.4R3.4 built by builder on 2001-08-04 03:37:39 UTC
> ILMID release 4.4R3.4 built by builder on 2001-08-04 03:37:47 UTC
> jkernel-dd release 4.4R3.4 built by builder on 2001-08-04
> 03:30:12 UTC
> jroute-dd release 4.4R3.4 built by builder on 2001-08-04
> 03:59:04 UTC
> jdocs-dd release 4.4R3.4 built by builder on 2001-08-04
> 04:06:50 UTC
>
>
> "Walk with me through the Universe,
> And along the way see how all of us are Connected.
> Feast the eyes of your Soul,
> On the Love that abounds.
> In all places at once, seemingly endless,
> Like your own existence."
> - Stephen Hawking -
>
>
>
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> http://puck.nether.net/mailman/listinfo/juniper-nsp
More information about the juniper-nsp
mailing list