[j-nsp] PE-2E3 with Cisco VXR

[K.K. Verma]

Hi,

Juniper E3 works in clear channel mode by default. While, Cisco PA-E3 
works in Digital-link mode by default.

There is one way to connect Juniper E3 to a Cisco PA-E3 using DSU mode 
of Digital-link.

At Juniper side:
Configure PA-E3 to work in Digital-link mode with subrating of 33.7 Mbps

At Cisco side:
Configure PA-E3's DSU bandwidth = 33700 kbps

I am sure it will help you.

Thanks,
KK Verma


Lars Erik Gullerud wrote:

>On Tue, 2004-01-20 at 17:55, Alexandre Abreu wrote:
>
>>Anyone successfully tried to connect a Juniper PE-2E3 PIC to a Cisco
>>PA-2E3 using a DSU mode other than kentrox? I'm targetting the use of
>>digital link dsu mode (no subrate) but it doesn't work well. The link
>>comes up, but there's a lot of packet loss. I've tried all
>>combinations for clock sources, scrambling modes, ... but can't seem
>>to get it to work properly.
>>
>
>We have tried that and experienced the same problems you are describing
>(lots of errors on the interface). By playing around with various
>e3-options it got somewhat better (I seem to remember we needed to set
>the "e3-options idle-cycle-flag ones" among other things), but since it
>seems like Cisco and Juniper have a different opinion on "Digital Link"
>mode, we gave up playing around with it and just went with using Kentrox
>mode ("dsu mode 1" on the Ciscos) everywhere, since that works fine.
>
>/leg
>
>
>_______________________________________________
>juniper-nsp mailing list juniper-nsp at puck.nether.net
>http://puck.nether.net/mailman/listinfo/juniper-nsp
>

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/juniper-nsp/attachments/20040127/ae96c1c2/attachment.html