[j-nsp] Cisco to Juniper STM1 config

Daniel Verlouw daniel at eu.tachyon.net
Tue Jul 20 12:00:03 EDT 2004


Is the M5 set for SDH framing? It defaults to SONET, so if you haven't 
done so already, you need to change it under [edit chassis fpc X pic 
Y]. set framing sdh.

Also, post the relevant parts from the configs and "show interface 
extensive".

-Daniel.


On Jul 20, 2004, at 5:38 PM, Mark Johnson wrote:
> I am trying to get a Cisco 7200 PA-OC3-SMI talking to a Juniper 
> PE-4OC3-SMI card without much luck. This is currently back to back
> as a test but will have a telco provided SDH STM-1 circuit soon. I can 
> get two Cisco's to talk directly no problem.
>
> This is a simple point to point circuit. Could someone provide sample 
> config for these as a back to back and also for when there is
> a real circuit?



More information about the juniper-nsp mailing list