[j-nsp] (no subject)
S B
akdamar at gmail.com
Mon Apr 25 13:16:24 EDT 2005
thanks.
On 4/25/05, C. Hagel <nanog at lordkron.net> wrote:
> What exactly are you looking for in the logs? When this thread started
> you were looking for "interface logs", which from your setup and example
> output you are getting. You also want to see Protocol logs, these are
> going to be in a differect file. This is usually set under the [ system
> syslog ] section. If you are looking for protocol logs and interface
> up/down messages you will set it under [ system syslog ] with the
> command:
>
> root# set system syslog file messages any any
>
> this will give you all messages and will catch interface up/down as well
> as protocol transitions (along with a lot of other stuff).
>
> On Mon, 25 Apr 2005 19:08:06 +0300
> S B <akdamar at gmail.com> wrote:
>
> SB> Erdem,
> SB> Thanks again.I tried it.
> SB>
> SB>
> SB>
> SB> Below you can see my config.
> SB> [edit interfaces]
> SB>
> SB> M10i-re0# show
> SB> traceoptions {
> SB> file intf size 10m files 2;
> SB>
> SB> e1-0/0/0:2 {
> SB> traceoptions {
> SB> flag all;
> SB>
> SB>
> SB>
> SB> After I run monitor start intf I see a few log like these.
> SB>
> SB> Apr 25 18:46:32 Going idle, 11 sync writes, 9 sync reads, 0 ifstate
> SB> msgs, 0 ifstate reads, 0 rtb msgs, 0 rtb reads, 2422 usec
> SB> Apr 25 18:46:32 Received SIGCHLD, collecting zombies.
> SB> Apr 25 18:46:32 Received SIGCHLD, collecting zombies.
> SB>
> SB> But I expect ospf logs or other packets logs at least.
> SB> What do you think about?What is the problem?
> SB>
> SB>
> SB> On 4/25/05, Erdem Sener <erdem.sener at borusantelekom.com> wrote:
> SB> >
> SB> >
> SB> > Hi,
> SB> >
> SB> > You don't have to enable any flags on [edit interfaces] section. What
> SB> > you can do,
> SB> > if I understood you correctly, is something like:
> SB> >
> SB> > [edit interfaces]
> SB> > set traceoptions file intf-msgs size 10m files 50
> SB> > [edit interfaces ds-1/2/3:4]
> SB> > set traceoptions xxx
> SB> >
> SB> > where xxx could be "all", or "event" etc.
> SB> >
> SB> > Now when you run "monitor start intf-msgs", you should only see
> SB> > traceoption logs
> SB> > for the specific interface(s).
> SB> >
> SB> > Hope this helps,
> SB> > Erdem
> SB> >
> SB> > > -----Original Message-----
> SB> > > From: S B [mailto:akdamar at gmail.com]
> SB> > > Sent: Monday, April 25, 2005 6:07 PM
> SB> > > To: Erdem Sener
> SB> > > Cc: juniper-nsp at puck.nether.net
> SB> > > Subject: Re: [j-nsp] (no subject)
> SB> > >
> SB> > > Hi Erdem,
> SB> > > First of all thanks for your reply.It seems OK but when I
> SB> > > enable general flags on edit interfaces I see all of
> SB> > > interfaces traces.How can I only see only specific interfaces
> SB> > > logs? Is it possibble?
> SB> > >
> SB> > > On 4/25/05, Erdem Sener <erdem.sener at borusantelekom.com> wrote:
> SB> > > >
> SB> > > >
> SB> > > > Hi,
> SB> > > >
> SB> > > > You should specify the filename on [edit interfaces]
> SB> > > section. You can
> SB> > > > also enable general flags here, or insert
> SB> > > additional/different flags
> SB> > > > for individual interfaces.
> SB> > > >
> SB> > > > Cheers,
> SB> > > > Erdem
> SB> > > >
> SB> > > > > -----Original Message-----
> SB> > > > > From: juniper-nsp-bounces at puck.nether.net
> SB> > > > > [mailto:juniper-nsp-bounces at puck.nether.net] On Behalf Of S B
> SB> > > > > Sent: Monday, April 25, 2005 5:31 PM
> SB> > > > > To: juniper-nsp at puck.nether.net
> SB> > > > > Subject: [j-nsp] (no subject)
> SB> > > > >
> SB> > > > > Hi ,
> SB> > > > >
> SB> > > > > I have a problem with debugging in JUNOS .
> SB> > > > >
> SB> > > > > I set traceoptions flag all for an e1 interface in m10i
> SB> > > > > router.Usually when I want to see traces online I set
> SB> > > traceoptions
> SB> > > > > file then I operate monitor start file_name command.However
> SB> > > > > traceoptions file file_name command does not work for the
> SB> > > > > interface.How could I see the traceoptions log online for e1
> SB> > > > > interfaces .??
> SB> > > > >
> SB> > > > > cheers.
> SB> > > > > SB
> SB> > > > >
> SB> > > > > _______________________________________________
> SB> > > > > juniper-nsp mailing list juniper-nsp at puck.nether.net
> SB> > > > > http://puck.nether.net/mailman/listinfo/juniper-nsp
> SB> > > > >
> SB> > > >
> SB> > > > UYARI/NOTIFICATION:
> SB> > > >
> SB> > > **********************************************************************
> SB> > > > ***** Bu e-posta ve ekleri sadece gonderilen adres
> SB> > > sahiplerine aittir.
> SB> > > > Bu mesajin yanlislikla tarafiniza ulasmis olmasi halinde,
> SB> > > lutfen gondericiye derhal bilgi veriniz ve mesaji
> SB> > > sisteminizden siliniz. BORUSAN TELEKOM bu mesajin icerigi ve
> SB> > > ekleri ile ilgili olarak hukuksal hicbir sorumluluk kabul
> SB> > > etmez. Gonderen taraf hata veya unutmalardan sorumluluk kabul etmez.
> SB> > > >
> SB> > > > The information contained in this e-mail and any files
> SB> > > transmitted with it are intended solely for the use of the
> SB> > > individual or entity to whom they are addressed.If you
> SB> > > received this message in error, please immediately notify the
> SB> > > sender and delete it from your system.BORUSAN TELEKOM doesn't
> SB> > > accept any legal responsibility for the contents and
> SB> > > attachments of this message..The sender does not accept
> SB> > > liability for any errors or omissions.
> SB> > > >
> SB> > > >
> SB> > > **********************************************************************
> SB> > > > *****
> SB> > > >
> SB> > >
> SB> >
> SB> > UYARI/NOTIFICATION:
> SB> > ***************************************************************************
> SB> > Bu e-posta ve ekleri sadece gonderilen adres sahiplerine aittir. Bu mesajin yanlislikla tarafiniza ulasmis olmasi halinde, lutfen gondericiye derhal bilgi veriniz ve mesaji sisteminizden siliniz. BORUSAN TELEKOM bu mesajin icerigi ve ekleri ile ilgili olarak hukuksal hicbir sorumluluk kabul etmez. Gonderen taraf hata veya unutmalardan sorumluluk kabul etmez.
> SB> >
> SB> > The information contained in this e-mail and any files transmitted with it are intended solely for the use of the individual or entity to whom they are addressed.If you received this message in error, please immediately notify the sender and delete it from your system.BORUSAN TELEKOM doesn't accept any legal responsibility for the contents and attachments of this message.The sender does not accept liability for any errors or omissions.
> SB> >
> SB> > ***************************************************************************
> SB> >
> SB>
> SB> _______________________________________________
> SB> juniper-nsp mailing list juniper-nsp at puck.nether.net
> SB> http://puck.nether.net/mailman/listinfo/juniper-nsp
>
> --
> C. Hagel <nanog at lordkron.net>
> JNCIP #103
> --
>
>
More information about the juniper-nsp
mailing list