[j-nsp] RE: Problems copying re1 to re0

[zeng watchthinker]

I think you should use 'commit sync' for this purpose

>From: "Hemant Narkhede" <hemantn at houstontechnologies.com>
>Reply-To: hemantn at houstontechnologies.com
>To: <juniper-nsp at puck.nether.net>
>CC: dante at adelphiacom.net, edson.cardoso at gvt.net.br
>Subject: [j-nsp] RE: Problems copying re1 to re0
>Date: Wed, 29 Jun 2005 12:54:58 +0600
>
>Hi,
>
>I am facing problem with file copying from RE1 to RE0. My config as 
follows:
>
>chassis {
>     redundancy {
>         routing-engine 0 backup;
>         routing-engine 1 master;
>         failover on-loss-of-keepalives;
>         graceful-switchover {
>             disable;
>         }
>
>Also when I give command"Show chassis routing-engine",it shows me 
following
>outut for RE:
>
>Routing Engine status:
>   Slot 0:
>     Current state                  Present
>   Slot 1:
>     Current state                  Master
>
>When I copying file from RE1(master) to RE0 , Then I am getting following
>errors:
>
>ipbb at MD_M40e# run file copy /config/juniper.conf.gz
>re0:/var/tmp/copied-juniper.conf.gz
>re0: No route to host
>re0: No route to host
>error: put-file failed
>error: could not send local copy of file
>
>Whats should be the reason ????
>
>Hemant Narkhede
>M: +94.77.9101524
>
>
>"It matters not whether you win or lose; what matters is whether I win or
>loose"
>
>_______________________________________________
>juniper-nsp mailing list juniper-nsp at puck.nether.net
>http://puck.nether.net/mailman/listinfo/juniper-nsp

_________________________________________________________________
享用世界上最大的电子邮件系统― MSN Hotmail。 http://www.hotmail.com