[j-nsp] resetting and recovery of an ERX to factory defaults

[Umar Ahmed]

Hi all,
 
Basically I'm locked out of an ERX1410 in our lab, I cant console or vty to
it but its VR's are routing.
 
My question is .. whats the process to reboot the sucker and reload it to
default factory settings. Then I can paste in the config.
 
Appreciate your help !
 

Regards,

Umar Ahmed 




**********************************************************************
Any opinions expressed in the email are those of the individual and not necessarily the company. This email and any files transmitted with it are confidential and solely for the use of the intended recipient.  If you are not the intended recipient or the person responsible for delivering it to the intended recipient, be advised that you have received this email in error and that any dissemination, distribution, copying or use is strictly prohibited.

If you have received this email in error, or if you are concerned with the content of this email please e-mail to: e-security.support at vanco.info

The contents of an attachment to this e-mail may contain software viruses which could damage your own computer system. While the sender has taken every reasonable precaution to minimise this risk, we cannot accept liability for any damage which you sustain as a result of software viruses. You should carry out your own virus checks before opening any attachments to this e-mail. 
**********************************************************************