[j-nsp] resetting and recovery of an ERX to factory defaults

[Bostjan Fele]

Go into config mode and use command:
boot config factory-defaults

Regards,
Bostjan

-----Original Message-----
From: juniper-nsp-bounces at puck.nether.net
[mailto:juniper-nsp-bounces at puck.nether.net]On Behalf Of Umar Ahmed
Sent: Tuesday, May 03, 2005 3:08 PM
To: juniper-nsp at puck.nether.net
Subject: [j-nsp] resetting and recovery of an ERX to factory defaults

Hi all,

Basically I'm locked out of an ERX1410 in our lab, I cant console or vty to
it but its VR's are routing.

My question is .. whats the process to reboot the sucker and reload it to
default factory settings. Then I can paste in the config.

Appreciate your help !


Regards,

Umar Ahmed




**********************************************************************
Any opinions expressed in the email are those of the individual and not
necessarily the company. This email and any files transmitted with it are
confidential and solely for the use of the intended recipient.  If you are
not the intended recipient or the person responsible for delivering it to
the intended recipient, be advised that you have received this email in
error and that any dissemination, distribution, copying or use is strictly
prohibited.

If you have received this email in error, or if you are concerned with the
content of this email please e-mail to: e-security.support at vanco.info

The contents of an attachment to this e-mail may contain software viruses
which could damage your own computer system. While the sender has taken
every reasonable precaution to minimise this risk, we cannot accept
liability for any damage which you sustain as a result of software viruses.
You should carry out your own virus checks before opening any attachments to
this e-mail.
**********************************************************************

_______________________________________________
juniper-nsp mailing list juniper-nsp at puck.nether.net
http://puck.nether.net/mailman/listinfo/juniper-nsp