[j-nsp] Juniper M7i & Cisco 3650 vlan configuration difficulties
Rommel Rizzato
Rommel.Rizzato at irishbroadband.ie
Tue Jan 17 06:18:37 EST 2006
Hi
As far as I Know to have the sub-interfaces (Logical) tagged you should
have the primary physical interface tagged as well.
Cheers
Rommel
-----Original Message-----
From: juniper-nsp-bounces at puck.nether.net
[mailto:juniper-nsp-bounces at puck.nether.net] On Behalf Of Chris Davies
Sent: 17 January 2006 11:07
To: juniper-nsp at puck.nether.net
Subject: [j-nsp] Juniper M7i & Cisco 3650 vlan configuration
difficulties
I've got a Juniper M7i and a Cisco 3650. I need to run vlan-tagging on
the interface that connects the two due to another piece of hardware
which requires it.
Juniper:
ge-1/3/0 {
description "Aggregate LAN";
vlan-tagging;
link-mode full-duplex;
unit 0 {
vlan-id 2;
family inet {
address xx.xx.195.249/30;
}
}
}
Cisco:
interface GigabitEthernet0/1
no switchport
ip address x.x.195.250 255.255.255.252
As soon as I add the vlan-tagging to the gigE port on the Juniper, the
two units cannot communicate.
I also tried to configure the GigE port on the cisco as
interface vlan 2
ip address x.x.195.250 255.255.255.252
interface GigabitEthernet0/1
switchport access vlan 2
However, that also does not work. Cisco's vlan is an internal
designation, not 802.1q.
If I try to turn on 802.1q encapsulation:
#switchport trunk encapsulation dot1q
Command rejected: Gi0/1 not a switching port.
#switchport encapsulation dot1q
Command rejected: Gi0/1 not a switching port.
Is there a way to configure a port so that the primary interface doesn't
require vlan tagging, but a secondary interface does? Or, is there a
way to assign two other IPs as VLANS that are not attached to an
interface but are able to be reached through a direct IP address?
Thank you.
_______________________________________________
juniper-nsp mailing list juniper-nsp at puck.nether.net
http://puck.nether.net/mailman/listinfo/juniper-nsp
More information about the juniper-nsp
mailing list