[j-nsp] VPLS with 2 interfaces on the same router

["Krasimir Avramski"]

output-vlan-map {
    swap;
}


will do the trick ......
Also ignore  STP packets on  ce1, ce2 eth interfaces if in switch mode....


Krasi

------------------------------------------------------------------------



---Original Message----------------------------------
 FROM: yevgeniy.voloshin at gmail.com
 TO: sthaug at nethelp.no
 SUBJECT: Re: Re: [j-nsp] VPLS with 2 interfaces on the same router
 SENT: APRIL 17, 2007 04:21PM
 CC: juniper-nsp at puck.nether.net
--------------------------------------------------------
> my question is - that is wrong in my configuration, so VPLS not work(I can't
> ping CE1  CE2).
> I use cisco routers like CE, and see with 'show cdp neighbors' myself - on
> CE1 I see CE1 like neighbor and also on CE2 I see CE2.
> I do not configure any in BGP section, or
> some other section except that I write before.
> Also may be I must configure some input-vlan-map and output-vlan-map on my
> subinterfaces to join its in the same VPLS instance?
> 
> 
> As I write before I use 1x G/E IQ on my m7i:
> show chassis hardware
> Hardware inventory:
> Item Version Part number Serial number Description
> Chassis A1674 M7i
> Midplane REV 04 710-008761 CS5290 M7i Midplane
> Power Supply 0 Rev 02 740-008985 6081743 DC Power Supply
> Power Supply 1 Rev 02 740-008985 6081742 DC Power Supply
> Routing Engine REV 10 740-009459 1000627040 RE-5.0
> CFEB REV 08 750-010464 CN9963 Internet Processor II
> FPC 0 E-FPC
> PIC 0 REV 09 750-003873 CP9902 4x E1, RJ48
> PIC 1 REV 09 750-007641 CR6244 1x G/E IQ, 1000 BASE
> Xcvr 0 NON-JNPR PT6406943 SFP-LX
> FPC 1 E-FPC
> PIC 2 REV 07 750-009487 CM8139 ASP - Integrated (Layer-2-3)
> PIC 3 REV 08 750-009099 CS2332 1x G/E, 1000 BASE
> 
> 
> Can you provide some real working examples?
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
> 
>