[j-nsp] l2circuit for frame relay

[Alexander Koch]

Amos,

normally all ccc are vlan id / dlci 512-1023. You might want
to try 'extended-frame-relay-ccc' and it should take all of
those as CCC - but you will then not be able to use any of
the DLCIs for, say, IP or so. All CCC or 512-1023. I hope
that helps a bit already.

Alexander

On Mon, 6 August 2007 18:11:58 +0300, Amos Rosenboim wrote:
> Hello All,
> 
> We are trying to migrate a frame relay network onto our mpls network,  
> based on juniper M10i routers.
> We are using frame-relay-ccc encapsulation and l2circuit configuration.
> The problem is that we are unable to configure dlci values below 512.
> We get the following error when trying to configure units with dlci  
> below 512:
> 
> CCC or TCC on this interface must have a DLCI >= 512
> 
> Is this a known limitation?
> Can this be worked around somehow?
> 
> This forces us to change dlci values at customers routers, which  
> makes the migration problematic.
> Maybe the choice of ccc encapsulation is wrong, we have chose it just  
> because it is the first configuration we encountered.
> 
> Any advice would be welcomed.
> 
> 
> Regards
> 
> Amos