[j-nsp] Adding static IPv6 neighbor entries

[Harry Reynolds]

Updating. The request for functionality was in 5.1, feature first
released in 8.3.

Sorry about that. The machine I tested on was 8.5.

Regards




> -----Original Message-----
> From: Harry Reynolds 
> Sent: Wednesday, August 29, 2007 12:58 PM
> To: Aaron Daubman; juniper-nsp
> Subject: RE: [j-nsp] Adding static IPv6 neighbor entries
> 
> Looks like this was added back in 5.1, but until you asked I 
> did not realize.  The record shows it was not tested, but the 
> syntax is not hidden; Not sure on docs. Syntax is similar to 
> a static arp, done under the interface's IPv6 address.
> 
> HTHs
> 
> [edit interfaces ge-3/1/1 unit 0 family inet6] 
> regress at camaro# set address 2001:db8:120:20::120/64 ?
> Possible completions:
>   <[Enter]>            Execute this command
> + apply-groups         Groups from which to inherit configuration data
> + apply-groups-except  Don't inherit configuration data from these 
> + groups
>   eui-64               Generate EUI-64 interface ID
> > ndp                  Static Neighbor Discovery Protocol  entries
>   preferred            Preferred address on interface
>   primary              Candidate for primary address in system
> > vrrp-inet6-group     VRRP group
>   |                    Pipe through a command
> [edit interfaces ge-3/1/1 unit 0 family inet6] 
> regress at camaro# set address 2001:db8:120:20::120/64 ndp ?
> Possible completions:
>   <address>            Destination IP address
> [edit interfaces ge-3/1/1 unit 0 family inet6]
> regress at camaro# set address 2001:db8:120:20::120/64 ndp     
> 
> > -----Original Message-----
> > From: juniper-nsp-bounces at puck.nether.net
> > [mailto:juniper-nsp-bounces at puck.nether.net] On Behalf Of Aaron 
> > Daubman
> > Sent: Wednesday, August 29, 2007 12:39 PM
> > To: juniper-nsp
> > Subject: [j-nsp] Adding static IPv6 neighbor entries
> > 
> > Greetings,
> > 
> > I'm looking to specify some static IPv6 neighbors on a 
> Juniper router 
> > running JUNOS 8.1R3.3.
> > 
> > I've found documentation specifying how to do this on Juniper's 
> > E-series routers running JUNOSe:
> > http://www.juniper.net/techpubs/software/erx/junose81/swconfig
> > -ip-ipv6-igp/html/ipv6-config19.html
> > 
> > but have not found anything comparable for JUNOS.
> > 
> > Any pointers?
> > 
> > Thanks as always,
> >      ~Aaron
> > _______________________________________________
> > juniper-nsp mailing list juniper-nsp at puck.nether.net 
> > https://puck.nether.net/mailman/listinfo/juniper-nsp
> > 
>