[j-nsp] STM-4 and Gig LACP Connectivity between Juniper and Ciscogear

[Samit]

Hi Jeff,

Since multilink ppp require adaptive service pic, Do I need any specific
interface or junos ver for LACP in Juniper? I am planning to get
P-1GE-SX  interface so what type of gbic do it need in the Catalyst switch?

Regards,
Samit


Jeff Tantsura wrote:
> Hi Samit,
> 
> Not all of Cisco's support LACP, some PAGP only which is Cisco proprietary.
> In this case you should configure Cisco in on mode and deactivate LACP on
> Juniper.
> 
> Regards,
> Jeff
> 
>> -----Original Message-----
>> From: juniper-nsp-bounces at puck.nether.net [mailto:juniper-nsp-
>> bounces at puck.nether.net] On Behalf Of Samit
>> Sent: woensdag 7 november 2007 12:36
>> To: juniper-nsp at puck.nether.net
>> Subject: [j-nsp] STM-4 and Gig LACP Connectivity between Juniper and
>> Ciscogear
>>
>> Hi,
>>
>> I am planning to get Juniper router and fit between two Cisco gear.
>> Since I don't have any practical knowledge in juniper gear and junos,
>> I would like to know expert opinion on any  known issues working between
>> Cisco and Juniper, STM and Gig interface and configs as per below figure.
>>
>> 	stm-4  -------------stm-4           Gig-----------Gig
>>         /                              \           /                   \
>> Cisco    (Multilink PPP)     Juniper      (LACP)      Catalyst
>>         \                              /          \                     /
>>         stm-4 --------------stm-4           Gig-----------Gig
>>
>> Thanks in advance.
>>
>> Regards,
>> Samit
>>
>>
>>
>> _______________________________________________
>> juniper-nsp mailing list juniper-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/juniper-nsp
> 
> 
>