[j-nsp] STM-4 and Gig LACP Connectivity between Juniper and Ciscogear

[Jeff Tantsura]

Hi Samit,

Not all of Cisco's support LACP, some PAGP only which is Cisco proprietary.
In this case you should configure Cisco in on mode and deactivate LACP on
Juniper.

Regards,
Jeff

> -----Original Message-----
> From: juniper-nsp-bounces at puck.nether.net [mailto:juniper-nsp-
> bounces at puck.nether.net] On Behalf Of Samit
> Sent: woensdag 7 november 2007 12:36
> To: juniper-nsp at puck.nether.net
> Subject: [j-nsp] STM-4 and Gig LACP Connectivity between Juniper and
> Ciscogear
> 
> Hi,
> 
> I am planning to get Juniper router and fit between two Cisco gear.
> Since I don't have any practical knowledge in juniper gear and junos,
> I would like to know expert opinion on any  known issues working between
> Cisco and Juniper, STM and Gig interface and configs as per below figure.
> 
> 	stm-4  -------------stm-4           Gig-----------Gig
>         /                              \           /                   \
> Cisco    (Multilink PPP)     Juniper      (LACP)      Catalyst
>         \                              /          \                     /
>         stm-4 --------------stm-4           Gig-----------Gig
> 
> Thanks in advance.
> 
> Regards,
> Samit
> 
> 
> 
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp