[j-nsp] BGP Configuration on J6350
Eric Van Tol
eric at atlantech.net
Wed Oct 3 12:08:23 EDT 2007
Try doing a 'show route advertising-protocol bgp x.x.x.x', where x.x.x.x
is the GSR address. It's quite possible that it is already sending a
full table and the GSR just isn't showing the inactive routes. I can't
remember what the default behavior is of Cisco, in terms of showing
routes received in 'show ip bgp summary'.
If you want to be sure, however, you can do the following:
policy-statement internal {
term term1 {
from protocol bgp;
}
then nexthop self;
}
}
That will re-advertise all routes learned through BGP to any peer on
which you've applied this policy.
-evt
> -----Original Message-----
> From: juniper-nsp-bounces at puck.nether.net
> [mailto:juniper-nsp-bounces at puck.nether.net] On Behalf Of
> Matthew Crocker
> Sent: Wednesday, October 03, 2007 12:03 PM
> To: juniper-nsp at puck.nether.net
> Subject: [j-nsp] BGP Configuration on J6350
>
>
> Hello,
>
> I'm new to JUNOS please bear with me.
>
> I have the following network setup
>
> ISP1 (AS7018) connected via OC-3 to GSR
> ISP2 (AS1239) connected via GigE to GSR
> ISP3 (AS16657) connected via GigE to J6350
>
> I have a GigE between the J6350 & GSR, My AS7849
>
> BGP with full tables running to all 3 ISPs
>
> ISP1 shows 227638 prefixes received (GSR)
> ISP2 shows 228612 prefixes received (GSR)
> ISP3 shows 227904 prefixes received (GSR)
>
> The J6350 is seeing 225992 prefixes from the GSR
> The GSR is only seeing 6141 prefixes from the J6350
>
> How do I configure the J6350 to send the full table to its IGP peer?
>
> show bgp summary shows
> show bgp summary
> Groups: 2 Peers: 2 Down peers: 0
> Table Tot Paths Act Paths Suppressed History Damp
> State Pending
> inet.0 453826 229366 0 0
> 0 0
> Peer AS InPkt OutPkt OutQ Flaps Last Up/
> Dwn State|#Active/Received/Damped...
> XXXXXXXX 7849 72875 14981 0 6 45:22
> 223250/225922/0 0/0/0
> XXXXXXXX 16657 41920 113 0 2 53:53
> 6116/227904/0 0/0/0
>
> show configuration protocols bgp
> path-selection always-compare-med;
> local-as 7849;
> group internal-within-AS7849 {
> type internal;
> local-address <ge-0/0/0.0 IP address>;
> export internal;
> graceful-restart;
> neighbor <GSR IP ADDRESS>;
> }
> group FiberTech {
> type external;
> export pl-announce;
> peer-as 16657;
> neighbor <FIBERTECH IP ADDRESS>;
> }
>
> show policy internal
> Policy internal:
> Term term1:
> then nexthop self
>
>
>
>
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>
More information about the juniper-nsp
mailing list