[j-nsp] Setting PE-4FE-TX port to 10m gives 'Illegal media change:invalid speed'

[Phil Sykes]

 Hi Ras,

 Unfortunately the Px-4FE-TX is 100M only - see
http://www.juniper.net/techpubs/software/junos/junos84/swconfig84-networ
k-interfaces/id-12154979.html

"Note: The statement speed (10m | 100m) applies only to the management
Ethernet interface (fxp0) and to the Fast Ethernet 12-port and 48-port
Physical Interface Cards (PICs). The 4-port and 8-port Fast Ethernet
PICs support a speed of 100 Mbps only."

 Would be nice to get a tri-state 10/100/1000 card for the M-Series like
the new ones in the J-Series!

Regards,

Phil
--
Phil Sykes
Technical Consultant	JNCIE-M #227
 
Imtech Telecom
Mobile:        +44 (0) 7823 530 630
http://www.imtechtelecom.co.uk/


> -----Original Message-----
> From: juniper-nsp-bounces at puck.nether.net 
> [mailto:juniper-nsp-bounces at puck.nether.net] On Behalf Of Ras
> Sent: 05 September 2007 10:47
> To: juniper-nsp at puck.nether.net
> Subject: [j-nsp] Setting PE-4FE-TX port to 10m gives 'Illegal 
> media change:invalid speed'
> 
> 
> I've just tried to set a port on an PE-4FE-TX to 10m (set 
> interfaces fe-0/0/1 speed 10m). This works fine on our 
> PE-12FE-TX and the 'commit check' says all is well, but when 
> I commit I get:
> 
> /kernel: %KERN-2: fe-0/0/1: Illegal media change: invalid speed
> 
> Are these 100m only ports? If not, what else might be wrong?
> 
> Thanks,
> Ras
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net 
> https://puck.nether.net/mailman/listinfo/junip> er-nsp
> 
> 
> 
> ______________________________________________________________________
> This email has been scanned by the MessageLabs Email Security 
> System. For more information please visit 
> http://www.messagelabs.com/email 
> 
> ______________________________________________________________________
>