[j-nsp] 'Lost connection to re1' error on T-series running 8.4R1.13

[David Ball]

  Haven't touched fxp1 or 2.  'commit synchronize' is configured under
[edit system].  Just checked both REs and configs were last synch'd at
the same time (off by 1 sec) and contents look identical.  Made a
minor change to config (annotation), ran a 'commit full' and saw
change propagated to both REs.  'commit full' provides same errors as
standard 'commit' which for the time being SEEM benign.

David


On 16/09/2007, Erdem Sener <erdems at gmail.com> wrote:
> Hello,
>
>   You should never configure the following interfaces they're
> internally used for several hardware communication.
>
> fxp1 / bcm0 : communication to forwarding engine.
> fxp2 / em0 : communication between two routing engine in supported
> platforms with two routing engines.
>
>  That said, what happens when you do a 'commit full' and 'commit
> synchronize' ? Can you login to re1 and confirm that your
> configuration is sync'ed ?
>
> Cheers,
> Erdem
>
>
>
> On 9/17/07, Gunjan GANDHI <gunjan.gandhi at ericsson.com> wrote:
> > Check your fxp1 interface. Did you change anything on your fxp1
> > interface?
> >
> > -----Original Message-----
> > From: juniper-nsp-bounces at puck.nether.net
> > [mailto:juniper-nsp-bounces at puck.nether.net] On Behalf Of David Ball
> > Sent: Friday, 14 September 2007 3:41 AM
> > To: juniper-nsp at puck.nether.net
> > Subject: [j-nsp] 'Lost connection to re1' error on T-series running
> > 8.4R1.13
> >
> >   Hey gang.  Upgraded to 8.4R1.13 the other day on a T640, and this
> > morning I installed jweb on the same box.  Installed on re0 first, then
> > while still on re0, I installed jweb on re1 (using the 're1'
> > option at the end of the 'request system software add' command.
> > Seemed to install just fine.
> >   Now though, when I do any type of commit (even just a check), I see
> > the following, and was wondering if anyone had come across it:
> >
> > user at box# commit check
> > re0:
> > error:
> > Connection to re1 has been broken
> > configuration check succeeds
> > re1:
> > configuration check succeeds
> >
> > from 'show log messages':
> >
> > Sep 13 11:35:13  CLGRABLBW01-re0 mgd[19438]: UI_WRITE_LOSTCONN: Lost
> > connection to peer 're1'
> > Sep 13 11:35:13  CLGRABLBW01-re0 mgd[19438]: LIBJNX_EXEC_SELECT:
> > Unable to select input stream for command 'fbuf pipe': Bad file
> > descriptor
> >
> >   I'm not seeing any (obvious) ill effects otherwise, but figured I'd
> > ask.
> >
> > David
> > _______________________________________________
> > juniper-nsp mailing list juniper-nsp at puck.nether.net
> > https://puck.nether.net/mailman/listinfo/juniper-nsp
> > _______________________________________________
> > juniper-nsp mailing list juniper-nsp at puck.nether.net
> > https://puck.nether.net/mailman/listinfo/juniper-nsp
> >
>