[j-nsp] dymanic interfaces junose

[Diogo Montagner]

Usually you need wait a few minutes until all interfaces are deleted. Then
the right command to
remove the bulk config is:

no vlan bulk-config "test"

HTH
./diogo -montagner


On Fri, Jan 18, 2008 at 10:10 AM, SunnyDay <cscosunny at gmail.com> wrote:

> Hello
> In junose ihave this configuration on an interface:
>
> i/nterface gigabitEthernet 1/0/1
> shutdown
> mtu 1522
> encapsulation vlan
> vlan bulk-config "test"
> profile vlan bulk-config "test" "test pro"
> vlan bulk-config "test" vlan-range 567 667
>
> /my problem is that the interface is shutdown but i still have vlan
> subinterface,pppoe interface and ppp in down state
> and i cannot remove the "/vlan bulk-config "test" vlan-range 567 667" /from
> the interface because it says:/dynamic interface exists
>
> any ideas?
> /
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>