[j-nsp] Juniper M40e and ALU 7450 InterOp

[Richmond, Jeff]

It has been almost 2 years (if memory serves), but I did have this configured in our lab between a couple of M10i/M7i's and a 7750. It took a bit to actually get it to work from what I remember, but if you'd like I can dig up my old notes and see if I have the 7750 config archived (this would have been with the beta 3.x release, for what its worth).

Regards,
-Jeff

________________________________________
From: juniper-nsp-bounces at puck.nether.net [juniper-nsp-bounces at puck.nether.net] On Behalf Of Atul Kant [atulk at kadap.net]
Sent: Tuesday, February 05, 2008 7:05 PM
To: juniper-nsp at puck.nether.net
Subject: [j-nsp] Juniper M40e and ALU 7450 InterOp

Hi,



Does anyone tried or know if MPLS tunnel can be established between Juniper M40e and ALU 7450.



ALU 7x50 defines SDP for inter-node service tunnel. I am wondering if it is possible when defining the SDP to give the far-end address that is actually a Juniper M40e loopback

address and do a similar Juniper specific Config on the M40e.



Will this work ? I am planning to test this once I get the lab organized, meanwhile just trying to find out if anyone else has done it or has similar requirements.



Thanks,



Atul Kant

Data Solutions Specialist

IP Services

Alcatel-Lucent Australia

Phone ~ +617 3367 4149

Mobile ~ +614 4841 0812
_______________________________________________
juniper-nsp mailing list juniper-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/juniper-nsp