[j-nsp] min req on M20 to run 9.1

[Ravi Pina]

Yay me for answering a question that wasn't asked.
Coffee anyone?

show system storage

	This will show you available storage.
	/dev/ad0 is typically flash
	/dev/ad1 is typically HDD

request system reboot media [ disk | compact-flash ]

	Not fixing the problem, but sets which device
	to boot from.

-r



On Wed, Jul 23, 2008 at 02:11:13PM -0400, Ravi Pina wrote:
> "With JUNOS Release 9.0 and later, the compact flash
> disk memory requirement for JUNOS software is 1 GB."[1]
> 
> -r
> 
> [1] http://www.juniper.net/techpubs/software/junos/junos91/rn-sw-91/rn-sw-91.pdf
> 
> 
> 
> On Wed, Jul 23, 2008 at 10:59:45AM -0700, Marlon Duksa wrote:
> > Hi - I'm trying to upgrade an older M20 from Jun8.4 to 9.1 and this is the
> > message I get.
> > What boot device is in question here? I'm doing the upgrade from the hard
> > disk and not the install media. Is there any way to see this boot device by
> > show cmd?
> > 
> > Installing package '/var/tmp/jinstall-9.1R2.10-domestic-signed.tgz' ...
> > Verified jinstall-9.1R2.10-domestic.tgz signed by PackageProduction_9_1_0
> > Adding jinstall...
> > 
> > WARNING: This installation will not succeed.
> > WARNING: The boot device is less than 256M.
> > WARNING: A hardware upgrade is required.
> > 
> > ERROR: jinstall fails requirements check
> > ERROR: jinstall-9.1R2.10-domestic-signed fails post-install
> > 
> > [edit]
> > root at m20-nemo# run request system reboot
> > 
> > Thanks,
> > Marlin
> > _______________________________________________
> > juniper-nsp mailing list juniper-nsp at puck.nether.net
> > https://puck.nether.net/mailman/listinfo/juniper-nsp