[j-nsp] min req on M20 to run 9.1

[Yasuyuki Hamada]

Do you see this page?
http://www.juniper.net/techpubs/software/junos/junos91/rn-sw-91/frameset.html

Note: With JUNOS Release 9.0 and later, the compact flash disk memory requirement for JUNOS software is 1 GB. For M7i and M10i routing platforms with only 256 MB memory, see the Customer Support Center JTAC Technical Bulletin PSN-2007-10-001 at https://www.juniper.net/alerts/viewalert.jsp?txtAlertNumber=PSN-2007-10-001&actionBtn=Search.

-- 
Yasuyuki Hamada


On Wed, 23 Jul 2008 10:59:45 -0700
"Marlon Duksa" <mduksa at gmail.com> wrote:

> Hi - I'm trying to upgrade an older M20 from Jun8.4 to 9.1 and this is the
> message I get.
> What boot device is in question here? I'm doing the upgrade from the hard
> disk and not the install media. Is there any way to see this boot device by
> show cmd?
> 
> Installing package '/var/tmp/jinstall-9.1R2.10-domestic-signed.tgz' ...
> Verified jinstall-9.1R2.10-domestic.tgz signed by PackageProduction_9_1_0
> Adding jinstall...
> 
> WARNING: This installation will not succeed.
> WARNING: The boot device is less than 256M.
> WARNING: A hardware upgrade is required.
> 
> ERROR: jinstall fails requirements check
> ERROR: jinstall-9.1R2.10-domestic-signed fails post-install
> 
> [edit]
> root at m20-nemo# run request system reboot
> 
> Thanks,
> Marlin
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>