[j-nsp] (no subject)

[Boyd, Benjamin R]

SunnyDay,

I don't know the OID, but using snmpwalk.exe to find the outOctets you
would use the following:
snmpwalk.exe -v 1 -c "community" "device ip" ifOutOctets
Which will give you output resembling: (mib.ifIndex = outOctets)
ifOutOctets.35 = 3474330439
ifOutOctets.36 = 984860543
ifOutOctets.37 = 0
ifOutOctets.38 = 3450966616

>From here you'll have to find out the ifIndex of the interface you wish
to view:
In the juniper:
show snmp mib walk ifDescr

-Ben


-----Original Message-----
From: juniper-nsp-bounces at puck.nether.net
[mailto:juniper-nsp-bounces at puck.nether.net] On Behalf Of sunnyday
Sent: Monday, June 23, 2008 3:45 AM
To: juniper-nsp at puck.nether.net
Subject: [j-nsp] (no subject)

Hello anyone knows the OID or how can I view the output of the command: 

Show  egress-queue rates interface gigabitEthernet x/x/x

Via  SNMP?

Thank you 

 

 

 

 

 

_______________________________________________
juniper-nsp mailing list juniper-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/juniper-nsp



***************************************************************************************

The information contained in this message, including attachments, may contain 
privileged or confidential information that is intended to be delivered only to the 
person identified above. If you are not the intended recipient, or the person 
responsible for delivering this message to the intended recipient, Windstream requests 
that you immediately notify the sender and asks that you do not read the message or its 
attachments, and that you delete them without copying or sending them to anyone else.